EverFocus EDN850H user manual

Page 57

EDN850H

the Load button. The settings will be restored to the previous configuration.

Upgrade Firmware

Upgrade the EDN850H with the latest firmware.

Press Browse button to search firmware file. Press Upgrade button to upgrade the firmware.

Note 1: Do not disconnect power to the unit during the upgrade. The unit reboots automatically after the upgrade has completed. (1-5 minutes.)

2.During upgrading process, all event recording actions will be stopped. It will continue to record after the camera is rebooted.

57

Image 57

Contents EDN850H EDN850H EDN850H About this document Safety NoticeTerms and Trademark SupportAbout AC Adaptor Table of Contents EDN850H Introduction Accessing the Camera Menu EDN850H EDN850H Setting Information System Info2 Log User Config EDN850H Network NetworkIP address IP TypeSubnet Mask GatewayEDN850H Primary DNS PasswordSecondary DNS UsernameEDN850H Bandwidth SMTP/FTP EDN850H Video Network Alarm reserved for PowerConMulti Streaming Camera SET button Shutter EDN850H 4.4.2.1 LensPress SET button when you finish all the settings EDN850H 4.4.2.3 White Balance Control AGC Auto Gain Control EDN850H 4.4.2.4 BacklightEDN850H 4.4.2.6 DNR Dynamic Noise Reduction EDN850H 4.4.2.7 SENS-UP EDN850H 4.4.2.8 Special Color ADJ Adjust the Color Gain from 0 ~ Motion Detection AREA1 AREA2 AREA3 AREA4 EDN850H Privacy TOP EDN850H Color ADJ Level Exit Audio User Event Event EDN850H Motion Alarm Time Mask EDN850H Date/Time SystemEDN850H Daylight Saving SD Card Indication Description Browse MaintenanceEDN850H Specifications Physical USA Office Head Office China OfficeEurope Office USA N.Y. Office