EverFocus user manual EDN850H 4.4.2.1 Lens, Shutter

EDN850H 4.4.2.1 LENS

1.When the SETUP menu is displayed on the screen, please direct the arrow to point to “LENS” by using the UP and DOWN buttons. Press the SET button to adjust IRIS level (the higher is brighter). In most cases, you don’t need to adjust this, since Lens is Auto Iris supported.

SETUP
> LENS	DC <┘		LENS
SHUTTER	___	> LEVEL	+++++++++ 20
WHITE BAL.	ATW
BACKLIGHT	OFF
AGC	MIDDLE
DNR	LOW
SENS-UP	AUTO <┘
SPECIAL <┘
EXIT

Note:

Since DC lens is a built-in lens for EDN850H camera, it does not support Manual lens, please do not select lens as Manual mode, it disables sens-up and may cause malfunction of lens.

2.Please press SET button for saving setting and return to the previous menu.

4.4.2.2 SHUTTER

1.When the SETUP menu is displayed on the screen, please direct the arrow to point to “SHUTTER” by using the DOWN button.

2.Select the shutter mode by pressing the LEFT or RIGHT button. Three modes are available: FLK, ESC and Manual.

Note:

Since DC lens is a built-in lens for EDN850H camera, shutter does not support ESC and Manual functions. ESC and Manual are reserved functions, please do not select these two options in normal situation.

ÖFLK: Please select “FLK” mode when flickering occurs on the screen, which is caused by an irregular balance between illumination and frequency. NTSC model: 1/100, PAL model: 1/120.

27