|
|
|
|
|
| Using LG EzSign 3.0 Editor 17 | ||
|
|
|
|
|
|
|
| |
Sending via a Wireless Network | ꔈꔈ New EzSign TV content will always replace | |||||||
|
|
|
|
|
| existing content without a notification | ||
Using a wireless network, you can send content | message. | |||||||
ꔈꔈ A password must be set for the router to | ||||||||
files saved on a PC to the TV without having to | ||||||||
prevent other devices from being connected. | ||||||||
connect a USB device. To use this function, you | ||||||||
1 Connect a wireless dongle to the TV that you | ||||||||
must first connect a wireless dongle to the TV in | ||||||||
order to connect to the wireless network. (See the | are connecting to the router. You can check the | |||||||
Network Setting section.) The PC must also be | network connection status from the TV's network | |||||||
connected to a router via a wired or wireless | menu. (The network must be connected to the | |||||||
connection. | minimum gateway.) | |||||||
|
| USB | - For details on network connections, see page 19. | |||||
|
|
|
| |||||
|
|
|
|
|
| 2 Connect the PC to the router via a wireless/ | ||
|
|
| wired connection. | |||||
| PC Editor S/W | |||||||
|
|
|
|
|
| 3 In EzSign 3.0 Editor, select Send via Wireless | ||
|
|
|
|
|
| |||
|
|
|
|
|
| Network. | ||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
4 Use the Refresh button to automatically scan for
| TVs connected to the router. You can also | |
| select Add TV to manually enter the IP address | |
Note | of a TV. | |
5 Select a TV you want to connect and then select | ||
ꔈꔈ The wireless dongle must be connected to the | ||
Send. | ||
wireless dongle slot among the USB slots on | ||
| ||
the TV. |
| |
ꔈꔈ If a content file is sent via the wireless dongle, |
| |
the file is immediately saved in the TV memory. |
| |
ꔈꔈ The connection may not be established |
| |
depending on wireless signal interference or |
| |
strength. |
|
NOTE
ꔈꔈ If there is wireless signal interference, check whether the router is operating normally and connect it again. When there is a wall or anoth- er router between the router and the TV it may not work properly. Remove any obstacles before installing it.
ꔈꔈ When multiple TVs are connected to a single router, make sure that the router is working properly before setting a network.
6 When sending is complete, the sent content file is immediately played on TV.
NOTE
ꔈꔈ The first time the TV is shown on the list it is identified by its serial number.
You can give it a new name (up to 16 characters)
ꔈꔈ
ꔈꔈ External Internet environments are not supported.
by clicking the TV name.