FujiFilm DL-290S owner manual Selecting the Exposure Mode, Move the camera slightly and.... Fig

Page 17

Fig. 23

2. Move the camera slightly and.... (Fig. 23)

aim the Autofocus Spot so that it covers some part

 

 

of your subject, then press the Shutter Release

 

about halfway down (to lock the focus) and make

 

sure the Autofocus Lamp (focusing completed

 

signal) has turned on.

3.While pressing the shutter release about halfway down... (Fig. 22)

move the camera back to its original position, recompose your picture, then take it by pressing the Shutter Release all the way down.

The autofocus Lock can be used as many times as necessary before tripping the shutter.

SELECTING THE EXPOSURE MODE

A word on the camera’s flash exposure modes

Each time you press in the Exposure Mode Button, the exposure mode setting will switch in the order shown below:

Auto flash (No sign), Red-eye Reducing (b), Fill-in Flash (c) and Flash off (d) mode.

17

Image 17
Contents OWNER,S Manual Contents Special FeaturesNames of Parts Insert the battery Fig Basic ProcedureOpen the battery compartment cover Fig Printing dates or time on your pictures Fig Using the Data or Time Printing UnitCheck the loaded battery Fig Year Month Day Month Day Year Day Month Year Day Hour Minute Attach the Strap Fig Insert the film Fig Open the camera back FigClose the camera back Fig Check the film tip position FigStandard 35 mm size covering area Fig Turn on the power FigZooming to wideangle Fig Zooming to telephoto FigHold the camera still Fig Take your picture Fig Press the shutter release about halfway down Fig END of Film Unload the exposed film Fig After exposing the last frame FigThis is the picture you want but.... Fig Unloading the film in mid-roll FigWord on the camera’s flash exposure modes Selecting the Exposure ModeMove the camera slightly and.... Fig Taking ordinary pictures Automatic-flash mode in low light FigEffective flash range If you want your subject’s eyes to look natural Red-eye reducing mode FigBeautiful Word on red-eye effectTaking non-flash pictures Flash off mode Fig Start the Self-timer Fig Set the self-timer FigWait 10 seconds Using the Remote Control SwitchTake out the remote control switch Fig Take your remote control picture Fig Set the camera to remote control FigEffective switch range Fig Faults Possible Causes Remedies Camera FAULTS, Possible CAUSES, and RemediesFaults Possible Causes Remedies Print FAULTS, Possible CAUSES, and Remedies Faults Possible Causes Remedies Camera Care and Cautions Specifications Power Source Self-timerRemote Control Switch OthersFGS-991102-Ci-01