Nikon WP-CP3 user manual Temperature

Page 6

Temperature

Do not leave the case in areas exposed to high temperatures, such as inside a car, near a heater, on a beach, or in direct sunlight. Failure to observe this precaution could weaken or warp the case, resulting in damage to the camera. Sudden changes in temperature could result in condensation inside the case, which could also damage the camera. To prevent condensation:

Before exposing the case to sudden changes in temperature, place it in a sealed plastic bag. Do not open the bag until the case has reached the same temperature as its surroundings.

Place the supplied desiccant (silica gel) in the case with the camera as directed on page 10 of this manual.

Do not expose the case to high temperatures by leaving it on the beach or in direct sunlight before entering the water.

Chemicals

Do not expose the case to volatile chemicals or their vapors. Failure to observe this precaution could result in damage to the case.

Do not use chemical detergents, rust inhibitors, thinner, alcohol, or other volatile chemicals when cleaning the case. Wash in fresh water only.

Use only desiccants designated for use with this product (see page 19).

Use only COOLPIX O-ring grease designated for use with this product (see page 19). Do not use NIKONOS O-ring lubricant (grease).

Do not use sealants or anti-fog chemicals.

Do not handle the case after applying sunscreen. Sunscreen can damage the clear plastic parts of the case.

Do not apply stickers to the case, as the adhesive could cause the case to deterio- rate.

Travelling by Air

If possible, include the case in your carry-on baggage when travelling by air. When packing the case with checked luggage, leave the case open or remove the O-ring. If the case is sealed, changes in air pressure may damage the case or prevent the case from opening.

High Altitudes

When travelling from high to low altitudes, open the case periodically to equalize the pressure. If the case is kept sealed, changes in air pressure may damage the case or prevent the case from opening.

iv

Image 6
Contents Waterproof Case WP-CP3 User’s ManualFor Your Safety Turn camera off immediately in the event of malfunctionDo not dive while holding Iii Temperature Table of Contents Important Use Only with Compatible Cameras Life-Long LearningPackage Contents IntroductionParts of the WP-CP3 Attaching the StrapIntroduction Follow these steps when using the waterproof case OverviewTurn the camera on Adjust settings Take pictures Caring for the O-ring StorageCheck for Leaks Check for Leaks Ready the Camera Select Underwater modeInsert the Camera BatteriesLatch forward and open the buckle Insert the CameraTurn the camera off Release the buckle Open the caseInsert Desiccant Perform a Final CheckReplacing the Desiccant Close the Case Check for Leaks Again Adjust Settings Take PicturesTurn the Camera On Use the Monitor Take PicturesDon’t Block the Shot Era is in the case. Use the monitor to frameDrying the Case Clean the CaseWash the case in fresh water Removing the CameraCleaning the Interior of the Case Do Not Exposure to Sunlight or HeatDo Not Use Force or Sharp Objects MaintenanceCaring for the O-ring Replacing the O-ringCleaning Grease the O-ringStorage Optional AccessoriesTechnical Notes SpecificationsBenutzerhandbuch Sicherheitshinweise WarnhinweiseVerwenden Sie das Produkt nur bis maxi- mal 40 m Wassertiefe Achtung Vermeiden einer UndichtigkeitTemperatur Inhaltsverzeichnis Einsetzen der Kamera in das GehäuseHinweise Immer auf dem neuesten StandEinführung Der PackungsinhaltDas Unterwassergehäuse WP-CP3 in der Übersicht Befestigen des TrageriemensLöschtaste Übersicht Verwenden des WP-CP3Schritt 4 Fotografieren Schritt 1 Überprüfen der Dichtigkeit Schließen Sie das GehäuseVerriegeln Sie das Gehäuse Prüfen Sie auf Dichtigkeit Testen Sie die BedienelementePrüfen Sie, ob Wasser in das Gehäuse einge- drungen ist Wählen Sie den Unter Wasser Modus Schritt 2 Einsetzen der Kamera in das GehäuseVorbereiten der Kamera Entfernen Sie den Trageriemen der KameraEinsetzen der Kamera Öffnen Sie das GehäuseSetzen Sie die Kamera ein Einlegen des Trockenmittels Letzte KontrolleSchließen des Gehäuses Klappen Sie das Gehäuse zuSchritt 3 Erneutes Überprüfen der Dichtigkeit Schritt 4 Fotografieren Einschalten der KameraEinstellen der Kamera Wählen Sie den Bildausschnitt FotografierenHalten Sie die Kamera aufnahmebereit Stellen Sie scharf und lösen Sie ausWischen Sie das Gehäuse trocken Schritt 5 Reinigen des UnterwassergehäusesSpülen Sie das Unterwassergehäuse unter klarem Wasser ab Nehmen Sie die Kamera herausLassen Sie das Gehäuse an einem geeigneten Ort trocknen Reinigen der Innenseite des GehäusesNehmen Sie den O-Ring heraus PflegeanleitungPflege des O-Rings Riss Kontrollieren Sie den O-RingFetten Sie den O-Ring Setzen Sie den O-Ring einÜberprüfen Sie die Dichtung Technische Daten Technische HinweiseAufbewahrung Optionales ZubehörManuel de lutilisateur Pour votre sécurité ’utilisez pas votre matériel en présence de gaz inflammableMaintenez le caisson étanche Eviter l’entrée d’eau Température Table des matières Avertissements Formation permanenteContenu de la boîte Descriptif du WP-CP3 Fixation de la dragonneIntroduction Présentation générale Effectuer une derNière vérification Son Étape 3 Vérifier à nouveau l’étanchéité du caisson Entretien du joint torique RangementÉtape 1 Vérifier l’étanchéité du caisson Fermer le caissonImmerger le caisson Vérifier l’étanchéité Vérifier que l’eau n’est pas rentrée dans le caissonPréparer l’appareil photo Accus/ pilesIntroduire l’appareil photo Ouverture du caissonEffectuer une dernière vérification Remplacement de l’absorbeur d’humiditéPlacer l’absorbeur d’humidité Le joint torique est-il craquelé ou abîmé?Fermer le caisson Étape 3 Vérifier à nouveau l’étanchéité du caisson Étape 4 Photographier Mettre l’appareil sous tensionRégler les paramètres Utiliser le moniteur Photographier’entravez pas la prise de vue Mettre au point et déclencherEssuyage du caisson Étape 5 Nettoyer le caissonNettoyer le caisson dans de l’eau douce Retrait de l’appareil photoNettoyage de l’intérieur du caisson Retirer le joint torique Remplacement du joint toriqueEntretien du joint torique Inspecter le joint toriqueGraisser le joint torique NettoyageRangement Accessoires optionnelsRemarques techniques Caractéristiques사용설명서의 일부 또는 전부를 무단으로 전재하는 것은 엄 격히 금지합니다

WP-CP3 specifications

The Nikon WP-CP3 is a versatile waterproof case designed to protect select Nikon cameras, allowing photography enthusiasts to explore underwater environments without compromising their equipment. With its robust construction and intuitive design, the WP-CP3 enables users to capture stunning images and videos in challenging conditions.

One of the most notable features of the WP-CP3 is its impressive waterproof depth rating. The case can withstand depths of up to 30 meters, making it suitable for a wide range of water activities, from snorkeling to scuba diving. This depth capability ensures that photographers can confidently venture into aquatic environments, knowing their camera is protected from water damage.

The WP-CP3 is constructed from durable polycarbonate material, providing both strength and lightweight portability. Its transparent design allows for easy framing and composition of shots underwater while maintaining visibility of the camera controls. This is particularly important for photographers who require precise adjustments in lighting and focus even when submerged.

In terms of usability, the WP-CP3 incorporates ergonomically designed controls, enabling photographers to access essential functions without removing the camera from the case. Buttons for shutter release, zoom control, and mode selection are intuitively placed for easy operation. This thoughtful design ensures that users can quickly capture moments without fumbling, even in demanding conditions.

The WP-CP3 also features an anti-fog system, which helps to minimize condensation and maintain clarity in underwater shots. This technology is valuable for photographers who frequently transition between different temperatures or move from above water to below, ensuring a seamless shooting experience.

Compatibility is another strong point of the WP-CP3. Designed for specific Nikon models, it seamlessly integrates with select cameras, allowing full functionality and performance without hinderance. This tailored fit means that users do not have to sacrifice quality or functionality when utilizing the case.

In summary, the Nikon WP-CP3 is a reliable and robust waterproof case that empowers photographers to capture breathtaking underwater imagery. With its impressive depth rating, durable construction, intuitive controls, and anti-fog technology, the WP-CP3 stands out as an essential accessory for anyone looking to push the boundaries of their photography in aquatic environments. Whether exploring coral reefs or capturing the beauty of underwater wildlife, the WP-CP3 ensures that photographers can do so with confidence and ease.