Philips Video Camera Accessing On-Screen Menu Utility, How to control On-Screen Menu Utility, Esc

Page 15

3.Program and Operation 3.1 Selecting Dome Camera

Before you program or operate a dome camera, you must select the dome camera by pressing the dome camera No. + CAM successively.

Example: Pressing 1, 0 and CAM key sequentially will select dome camera 10. The selected dome camera ID will be displayed on the LCD monitor of the keyboard controller.

3.2 Accessing On-Screen Menu Utility

You can call up the On-screen menu utility on your monitor by pressing MENU key on the keyboard controller, the following On-screen menu utility will appear:

DOME MENU

AUTO SCAN

PRESET

TOUR

PATTERN

ALARM

AREA TITLE

PRIVACY ZONE

CAMERA

DOME SETUP

EXIT(ESC TO EXIT)

3.3 How to control On-Screen Menu Utility

	Action	Function

	MENU	Call on On-screen menu utility

		Go into the sub-menu items.
	Joystick left or right	Execute the command (exit)
	Joystick left or right	Change value.
		Change value.
		Navigate through the menu items.
	Joystick up or down	Navigate through the menu items.

	Joystick down	Finish editing title. Same effect as Enter key

	Zoom handle twist	Change value.
	Zoom handle twist	Enter editing title mode at Preset menu.
		Enter editing title mode at Preset menu.
	CTRL + Joystick	PTZ control of the selected camera

	ESC	Escape (EXIT)

15

Image 15

Contents Installation and Operating Manual Contents Introduction 1.1 Features Safety InstructionsAssemble bubble ring ass’y Push Bubble ring ass’y Screw Remove windowDifferent version will not support alarm input and output Installation and Configuration 2.1 Package ContentsBasic Configuration of Fastrax II Dome Camera System STP AWG #24BNC Single Multiplexer 24VACBNC BNC Pin No Single User with Two Multiplexer1st Main Monitor Spot Monitor 1st MultiplexerTwo Multiplexer with Slave Keyboard Controller Two Multiplexer with Slave Keyboard Controller method Two Multiplexer with Slave Keyboard Controller methodSW1 Setting Unit for TerminationSetting Address ID of Dome Camera Beyond ID 999, contact your service providerDome ID Camera Setting Protocol of Dome CameraOff Function ProtocolTitle Alarm Display RAM Test Check NO. OK Check Aaaa OKConnection Getting StartedESC Accessing On-Screen Menu UtilityHow to control On-Screen Menu Utility MenuQuick move Auto Scan SetupScan AUTOSCAN01 END AngleAUTO/ Manual Preset SetupJOY-LEFT to PREV. Save and Exitesc to Cancel Follow steps below to store the Preset positionsDwell Shortcut of Preset ProgramGuard Tour Setup Scan Type NormalFollow steps below to program the Pattern Pattern Setup TitleArea Title Setup PRSTitle Start END ACB ==== Not at EDC-142E1 SharpnessBack Light Digital ZoomEDC-143E WB white balance ControlAE Control Exit ESC to Exit Line Lock ControlMode Local ControlLanguage Setup Home Function SetupFollow these steps to program the Home position Dome OSD Display View Angle SetupOSD Display View DirectionInitialize Data Panning RangeFlip Tilt Over AngleSystem Information TroubleshootingDome Reset Problem Possible SolutionWDR GlossaryShort Cut Key EDP SpecificationsBackup Alarm processingAlarm inputs Remote controlDimensional Drawings