Shortcut of Preset Program, Guard Tour Setup

3.6 Shortcut of Preset Program

Select a view to be stored (direction of the camera, zoom and focus), then press No. (1 to 240), and then press Pgm, Prst subsequently. The current view will be stored to the selected preset number if position is empty. If selected preset number is not empty, „PRESET EXISTING” message will be displayed on the monitor and ask to overwrite.

Example: 1, 0, 1 + Pgm + Prst will store current view as preset No. 101. In this case, focus and Iris mode will be programmed as Auto, dwell time will be set to 3 sec.

3.7Tour (THIRD ITEM OF THE MAIN MENU / SHORTCUT: Tour)

There are 8 programmable Tours. Each Tour consists of up to 42 Preset positions, Patterns, Scans or other Tours (second-level). Using second-level Tours, it can be expanded to over 300 functions in a single Tour. However Tours in second level Tour will be ignored when called by a Tours. The following example illustrates this concept:

If	Tour1 has Preset1 Preset2 Tour2 Tour3 and

Tour2 has Preset3 Preset4 Preset5 Tour4 and

Tour3 has Preset6 Pattern1 and

Tour4 has Preset7.

Tour1 executes as follows:

Preset1 Preset2 Preset3 Preset4 Preset5 Preset6 Pattern1

Preset1 ... (Repeat)

Tour2 executes as follows:

Preset3 Preset4 Preset5 Preset7 Preset3 ... Repeat (Tour4 is still valid if called directly from Tour2.)

GUARD TOUR SETUP

TOUR 01 : xxxxxxxxxxxxxxxx

SCAN TYPE : NORMAL

DWELL : 03

=== === 003 === === === ===

A08 === === === === === ===

=== T02 === 001 === === ===

=== === === T08 === === ===

=== === === === === === ===

SAVE AND EXIT (ESC TO CANCEL) PRESS FUNCTION KEY AND ROTATE JOYSTICK TO SELECT NUMBER.

xxxxx: 16 digits of title for tour label

=== : blank preset position

SCAN TYPE : Max (Normal)/ Slow V. Scan/ Fast V. Scan

DWELL :	03-99 Sec
003 :	Preset 003 (1~240)
A08 :	Auto Scan 08 (1~8)
P01 :	Pattern 01 (1~4)
T02 :	Tour 02 (1~8)

Follow the steps below to program the Tours:

1.Press Menu to display the main menu on the monitor. Scroll to Tour and push the Joystick to the right to enter the Tour menu. Or just press the Tour key on the keyboard.

2.Choose an empty location to be programmed by pushing the Joystick up, down, right, or left.

3.To see a stored preset view, use the Joystick to move the cursor to a stored position. By pressing Prst key, the camera will move to the stored Preset view.