Philips Video Camera manual Basic Configuration of Fastrax II Dome Camera System, STP AWG #24, Bnc

Page 6

2.2 Basic Configuration of Fastrax II Dome Camera System

Power 24VAC

STP AWG #24

Alarm output	Alarm input
1 ~ 2	1 ~ 4

Sensor

Power 24VAC

Alarm input

up to 8

SirenBNC

Dome1+

Dome1–

Light
Alarm output	Monitor
up to 4	Monitor		Alarm output	Alarm input
up to 4			Alarm output	Alarm input
			3 ~ 4	5 ~ 8
			RS-485
			Half Duplex mode: RX+, RX–
			RS-422
			Simplex mode: (RX+), (RX–)
		BNC	Duplex mode: (TX+), (TX–), (RX+), (RX–)
		BNC
J-Box (Back)			J-Box (Front)

Up to 128 Dome cameras including 32 alarm mode can be connected at DOME2 port.

unshielded cable

DATA2 port should be connected in case that DOME2 port or DVR port are used.

unshielded cable

Rear

Keyboard controller

Figure 4- Basic installation diagram

The dome camera must be installed by qualified service personnel in accordance with all local and federal electrical and building codes. The system should be installed according to Figures 4 through 9.

6

Image 6

Contents Installation and Operating Manual Contents Safety Instructions Introduction 1.1 FeaturesPush Bubble ring ass’y Screw Remove window Assemble bubble ring ass’yInstallation and Configuration 2.1 Package Contents Different version will not support alarm input and outputBasic Configuration of Fastrax II Dome Camera System STP AWG #24BNC Single Multiplexer 24VACBNC BNC 1st Multiplexer Single User with Two Multiplexer1st Main Monitor Spot Monitor Pin NoTwo Multiplexer with Slave Keyboard Controller Two Multiplexer with Slave Keyboard Controller method Two Multiplexer with Slave Keyboard Controller methodSetting Unit for Termination SW1Setting Address ID of Dome Camera Beyond ID 999, contact your service providerDome ID Protocol Setting Protocol of Dome CameraOff Function CameraGetting Started Alarm Display RAM Test Check NO. OK Check Aaaa OKConnection TitleMenu Accessing On-Screen Menu UtilityHow to control On-Screen Menu Utility ESCEND Angle Auto Scan SetupScan AUTOSCAN01 Quick moveFollow steps below to store the Preset positions Preset SetupJOY-LEFT to PREV. Save and Exitesc to Cancel AUTO/ ManualScan Type Normal Shortcut of Preset ProgramGuard Tour Setup DwellPattern Setup Title Follow steps below to program the PatternArea Title Setup PRSTitle Start END ACB ==== Digital Zoom SharpnessBack Light Not at EDC-142E1WB white balance Control EDC-143EAE Control Local Control Line Lock ControlMode Exit ESC to ExitLanguage Setup Home Function SetupFollow these steps to program the Home position View Direction View Angle SetupOSD Display Dome OSD DisplayTilt Over Angle Panning RangeFlip Initialize DataProblem Possible Solution TroubleshootingDome Reset System InformationGlossary WDRShort Cut Key Specifications EDPRemote control Alarm processingAlarm inputs BackupDimensional Drawings