Safety Instructions

•Read these safety instructions and the operation manual first before you install and commission the camera.

•Keep the manual in a safe place for later reference.

•Protect your camera from contamination with water and humidity to prevent it from permanent damage. Never switch the camera on when it gets wet. Have it checked at an authorized service center in this case.

•Never operate the camera outside of the specifications as this may prevent the camera functioning.

•Do not operate the cameras beyond their specified temperature, humidity or power ratings. Operate the camera only at a temperature range of -10°C to +50°C and at a humidity of max. 90%.

•To disconnect the power cord of the unit, pull it out by the plug. Never pull the cord itself.

•Pay attention when laying the connection cable and observe that the cable is not subject to heavy loads, kinks, or damage and no moisture can get in. Do not attempt to disassemble the camera board from the dome.

•Do not attempt to disassemble the camera board from the dome.

•The warranty becomes void if repairs are undertaken by unauthorized persons. Do not open the camera housing. Maintenance and repair have to be carried out only by authorized service centers.

•Do not use strong or abrasive detergents when cleaning the dome. Use a dry cloth to clean the dome surface. In case the dirt is hard to remove, use a mild detergent and wipe gently.

NOTE: This is a class A digital device. This digital device can cause harmful interference in a residential area; in this case the user may be required to take appropriate corrective action at his/her own expense.

1.Introduction 1.1 Features

The Fastrax II Keyboard Controller and the Fastrax II dome cameras make up the building blocks for any surveillance/security system. Using multiple Keyboard Controllers and multiple dome cameras, no place is too large for monitoring. Extensible and flexible architecture facilitates remote control functions for a variety of external switching devices such as multiplexers and DVRs.

•Built-in 18x (23x,25x, 22x, 26x) times optical power zoom camera with True Night Shot function

•240 Preset positions

•8 Tours consist of Preset, Pattern, Auto-Scan and Tour itself can be programmed over 300 functions and Preset location. While moving, each Preset scan can be watched in smooth Vector Scan mode.

•8 Auto Scan including vector scan (and 1 endless Auto Scan at EDC-144E)

•4 Pattern (240seconds)

•8 Privacy zone

•8 Alarm input / 4 Aux out (NC & NO)

•Variable speed from 0.1°/sec to 90°/sec

•Turbo speed is Max 360°/sec with Ctrl key pressed

•Maximum speed is inversely proportional to the zoom ratio

•Maximum speed is 380°/sec when preset command.

•Programmable user preferences (alarm, preset, title, etc.)

•Up to 999 selectable camera addresses

•Built-in RS-485/422 receiver driver

•Clear bubble with black liner (shelter) for concealing the camera

•Optional Tinted Bubble, Indoor & Outdoor pendant housing with heater & blower, Indoor Flush Mount, Parapet mount & Roof Top mount