Philips Video Camera manual WB white balance Control, EDC-143E

Page 23

WB (white balance) CONTROL

EDC-141E EDC-142E EDC-144E

 

WB SETUP

MODE

: AUTO

R GAIN

: 210

B GAIN

: 155

EXIT (ESC TO EXIT)

 

MODE :

MANUAL / AUTO / INDOOR / OUTDOOR / ONE PUSH / ATW

RGAIN :

0 ~ 255

BGAIN :

0 ~ 255

Use the ATW mode for normal use.

RGAIN / BGAIN modes are controllable only in MANUAL Mode.

Push the Joystick to the right or left to change.

NOTE : „ONE PUSH” means that when rotating the Joystick handle for a moment the lens moves to adjust the focus for the subject. The focus lens then holds that position until the next rotating the Joystick handle.

EDC-143E

 

WB SETUP

MODE

: AUTO/MANUAL

R GAIN

: 133

B GAIN

: 133

EXIT (ESC TO EXIT)

 

MODE :

MANUAL / AUTO

RGAIN :

0 ~ 255

BGAIN :

0 ~ 255

Use the AUTO mode for normal use.

RGAIN / BGAIN modes are controllable only in MANUAL Mode.

Push the Joystick to the right or left to change.

EDC-142E1

 

 

EDC-142E2

 

WB SETUP

 

MODE

: AWB

 

R GAIN

: 85

 

B GAIN

: 85

 

EXIT (ESC TO EXIT)

 

MODE :

AWB / WAWB / INDOOR / OUTDOOR / MANUAL

 

WAWB:

Wide range auto white balance mode

 

RGAIN :

0 ~ 255

 

BGAIN :

0 ~ 255

 

Use the AWB mode for normal use.

RGAIN / BGAIN modes are controllable only in MANUAL Mode.

Push the Joystick to the right or left to change.

23

Image 23
Contents Installation and Operating Manual Contents Introduction 1.1 Features Safety InstructionsAssemble bubble ring ass’y Push Bubble ring ass’y Screw Remove windowDifferent version will not support alarm input and output Installation and Configuration 2.1 Package ContentsBNC Basic Configuration of Fastrax II Dome Camera SystemSTP AWG #24 BNC BNC Single Multiplexer24VAC Pin No Single User with Two Multiplexer1st Main Monitor Spot Monitor 1st MultiplexerTwo Multiplexer with Slave Keyboard Controller Two Multiplexer with Slave Keyboard Controller method Two Multiplexer with Slave Keyboard Controller methodSW1 Setting Unit for TerminationDome ID Setting Address ID of Dome CameraBeyond ID 999, contact your service provider Camera Setting Protocol of Dome CameraOff Function ProtocolTitle Alarm Display RAM Test Check NO. OK Check Aaaa OKConnection Getting StartedESC Accessing On-Screen Menu UtilityHow to control On-Screen Menu Utility MenuQuick move Auto Scan SetupScan AUTOSCAN01 END AngleAUTO/ Manual Preset SetupJOY-LEFT to PREV. Save and Exitesc to Cancel Follow steps below to store the Preset positionsDwell Shortcut of Preset ProgramGuard Tour Setup Scan Type NormalFollow steps below to program the Pattern Pattern Setup TitleTitle Start END ACB Area Title SetupPRS ==== Not at EDC-142E1 SharpnessBack Light Digital ZoomEDC-143E WB white balance ControlAE Control Exit ESC to Exit Line Lock ControlMode Local ControlFollow these steps to program the Home position Language SetupHome Function Setup Dome OSD Display View Angle SetupOSD Display View DirectionInitialize Data Panning RangeFlip Tilt Over AngleSystem Information TroubleshootingDome Reset Problem Possible SolutionWDR GlossaryShort Cut Key EDP SpecificationsBackup Alarm processingAlarm inputs Remote controlDimensional Drawings