Philips Video Camera Troubleshooting, Dome Reset, System Information, Problem Possible Solution

Page 29

• DOME RESET

This feature is used to re-calibrate the orientation of a selected dome camera. Origin offset value is not affected by this function. (Offset is still valid after origin set)

• SYSTEM INFORMATION

SYSTEM INFORMATION

CAMERA TYPE	: XXXXXXX
H/W VERSION	: V2.1
ROM VERSION	: V2.11
PROTOCOL	: F2E
BAUDRATE	: 9600BPS
EXIT (ESC TO EXIT)

A Dome camera’s Setup menu provides essential information about the dome camera when service is required. When you view this screen, you can determine the camera type, ROM version. The information on this screen cannot be modified.

4. Troubleshooting

If problems occur, verify the installation of the camera with the instructions in this manual and with other operating equipment. Isolate the problem to the specific piece of equipment in the system and refer to the equipment manual for further information.

Problem	Possible Solution
	Verify that power is connected to all pieces of equipment in the system.
No video	Verify that the power switches are in the ON position.
	Check the video connections (see Figures 4).
	Check that the BNC connectors are inserted properly.
	Check the voltage level of the dome camera.
Poor video quality	Check that 8 pin cable is connected to the Keyboard. Check 8 pin cable for Keyboard is
	proprietary. (Cable for video is shielded.)
	Check termination of Video.
	Reset the cameras using the Dome configuration menus.
Dome cameras lose their positions.	Check that the dome cameras are inserted properly in the base.
	Check the voltage level of the dome camera.
Camera number does not match the multiplexer number.	Check the camera ID and insert the BNC cable into the proper input of the multiplexer.
Picture is torn when switching	Check Line Lock setting and adjust phase of L/L (see page 25).

29

Image 29

Contents Installation and Operating Manual Contents Introduction 1.1 Features Safety InstructionsAssemble bubble ring ass’y Push Bubble ring ass’y Screw Remove windowDifferent version will not support alarm input and output Installation and Configuration 2.1 Package ContentsBNC Basic Configuration of Fastrax II Dome Camera SystemSTP AWG #24 BNC BNC Single Multiplexer24VAC 1st Main Monitor Spot Monitor Single User with Two Multiplexer1st Multiplexer Pin NoTwo Multiplexer with Slave Keyboard Controller Two Multiplexer with Slave Keyboard Controller method Two Multiplexer with Slave Keyboard Controller methodSW1 Setting Unit for TerminationDome ID Setting Address ID of Dome CameraBeyond ID 999, contact your service provider Off Function Setting Protocol of Dome CameraProtocol CameraConnection Alarm Display RAM Test Check NO. OK Check Aaaa OKGetting Started TitleHow to control On-Screen Menu Utility Accessing On-Screen Menu UtilityMenu ESCScan AUTOSCAN01 Auto Scan SetupEND Angle Quick moveJOY-LEFT to PREV. Save and Exitesc to Cancel Preset SetupFollow steps below to store the Preset positions AUTO/ ManualGuard Tour Setup Shortcut of Preset ProgramScan Type Normal DwellFollow steps below to program the Pattern Pattern Setup TitleTitle Start END ACB Area Title SetupPRS ==== Back Light SharpnessDigital Zoom Not at EDC-142E1EDC-143E WB white balance ControlAE Control Mode Line Lock ControlLocal Control Exit ESC to ExitFollow these steps to program the Home position Language SetupHome Function Setup OSD Display View Angle SetupView Direction Dome OSD DisplayFlip Panning RangeTilt Over Angle Initialize DataDome Reset TroubleshootingProblem Possible Solution System InformationWDR GlossaryShort Cut Key EDP SpecificationsAlarm inputs Alarm processingRemote control BackupDimensional Drawings