RCA manual Analog Camcorder or VCR Hollywood DV-Bridge

Method B: During the capture process, if the Hollywood DV-Bridge is connected for video output to an analog device, connect the TV monitor to the analog device. This process is explained later in this user’s guide, in the “Outputting Video” section. This method may be helpful if your TV monitor does not have the kinds of video and audio connectors described above. You may be able to connect the monitor to an analog output device such as a VCR by using a coaxial cable.

Method B results in the configuration shown below.

Analog Camcorder or VCR

Hollywood DV-Bridge Optional Preview Monitor

RCA Video Out RCA Video In

	Or
S-Video Out	S-Video In
Audio Out	Audio In

(To AC Power)

VHS

RCA Video Out RCA Video In

	Or
S-Video Out	S-Video In
Audio Out	Audio In
	OR
Coaxial Out	Coaxial In

TV

Back

IMPORTANT: Make sure that the camcorder or VCR and TV monitor are set up properly to receive a video signal. It may be necessary to set a camcorder to VTR mode, while a VCR or monitor might need to be set to “Line In,” “L1,” “L2,” “Aux” or a similar channel. Or, if the monitor is connected to a VCR with a coaxial cable, you may need to set the monitor to channel 3 or 4. Check each device’s documentation for specific details.

Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge With a PC • Page 21