Siemens 6DS2-510-0xx00-0xa0 manual Scope

Page 2

Product Information

February, 1999

BRIDGE CS-L2

 

1 Scope

The product information for the system software V02.00 remains valid. The following information represents a supplement.

The delivery consists of:

6DS2 510-0XX00-0XA0

6DS2 510-0XX00-0XB1 (Upgrade/Update)

 

 

BRIDGE CS-L2 Memory Card

Diskette 3,5" with BRIDGE CS-L2 software

Diskette 3,5" with tools for installation

Diskette 3,5" with tools for installation

Software contract and registration card

Software contract

Product Information

Product Information

 

 

Note on software protection:

The memory card must be considered as part of the CPU. If the memory card is removed during current operation, the BRIDGE CS-L2 enters STOP, as a result of the software protection, i.e. telegrams are no longer processed.

Attention:

Before commissioning, please read the current documentation carefully.

Product Information

present document

Technical

TELEPERM M Bridge CS-L2

Description

Technical Description

 

C79000-T8076-C707

 

included in:

 

Supplementary System Documentation ASx88/TM

 

C79000-G8076-C700

Copyright © SIEMENS AG 1996-1999. All Rights Reserved.

S79220-A0978-A-05-7637

Page 2 of 20

Image 2
Contents Bridge CS-L2 VarScope Commissioning Startup by Commissioning TerminalBridge CS-L2 Esccopytm IBSBEDI.386 Update by Programming Device PG740 Removed Errors from V02.00 toRemoved Errors already with Extended Functions Installing the new M7 CPU Replacing the CP5412-A1 with an IF964-DP interface moduleSlot Module Interface Use for Configuration Box File Instructions on installing the CPU Limited operating performance Configuration of the bus connections L2AMPRO.INIParameter of configuration file BRSYS.INI Examples of standard system settingsL2hsa = Parameter of configuration file DOSCONF.DAT for CP5412-A1L2ts = L2ttr =Example of a configuration file DOSCONF.DAT # File for Installing TF/IHI DriverBRSYS.INI . If different addresses are entered, Example of a configuration file L2AMPRO.INI Parameter of configuration file SYSPAR.INI Diomaskeein =255 Diomaskeaus =255 SchlFunction Assignment of the Inputs Connector Pin Assignment IF961-DIOFunction Assignment of the Outputs Status display and error messages Operational modes switch key switch