Sharp VL-NZ100S manual Installing the Lithium Battery

Page 25

Installing the Lithium Battery

Installing

The supplied lithium battery is used to store the memory of the date and time settings.

Removing

Perform steps 1 and 2 above, then lift out the battery from the battery holder.

1 Slide the cassette compartment door release and open the cassette compart- ment door.

Note:

The cassette holder will extend and open when the camcorder is connected to a power source. Be sure to close the cassette holder before proceeding to the next step (see page 12).

2 Pull out the lithium battery holder using a pointed object such as the tip of a ballpoint pen.

Notes on the Use of the Lithium battery

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type CR2025 recom- mended by the equipment manufacturer.

XKEEP THIS BATTERY AWAY

FROM CHILDREN. IF SWALLOWED,

CONSULT A PHYSICIAN IMMEDIATELY FOR

EMERGENCY TREATMENT.

ZBATTERY MAY EXPLODE IF

MIS-USED OR INSTALLED WITH POLARITY

REVERSED. DO NOT RECHARGE, DISAS-

SEMBLE OR DISPOSE OF IN FIRE.

Preparation

3 Insert the lithium battery into the battery holder with the Hside of the battery facing the

mside of the holder.

Lithium battery

holder

m” mark

• Do not short-circuit, recharge, disassemble, or

heat the lithium battery.

• Should the lithium battery leak, wipe the battery

compartment clean, and then insert a new

battery.

• The lithium battery will last about one year under

normal usage.

4 Push the battery holder back into position. Press the Wmark gently, then close the cassette compartment door by pressing the centre until it clicks into place.

14

VL-NZ100H-009-018

14

02.2.14, 9:58 AM

Image 25
Contents Gedruckt in Japan Imprimé au Japon TINSLA006WJZZ 02P03-JKG Sharp CorporationPower supply Special Note for Users in the U.K Supplied Accessories Optional Accessories Iii When using your camcorder in a cold enviDew Formation What is dew formation?Using a Cleaning Tape Commercially Available Precautions Dirty Video HeadsAvailable mode Causes of video head cloggingContents Contents Viii Digital Still Camera Features AppendixCompartment door Part NamesCard selection Media SelectionPp , 30 Operation ReferencesTAPE-VCR mode TAPE-CAMERA modeOn-screen Display Index Operation ReferencesCARD-VCR mode CARD-CAMERA modeExample screens shown are for TAPE-CAMERA mode On-screen indicators on/offManual screens AS S E T T E Properly inserted see Setting seeNew one see Card has no images recorded in the format the camcorder canAttaching Attaching and Removing the Battery PackRemoving PreparationExtending battery pack life Charging the Battery Pack1Fully charge the battery pack BatteryPreparation Powering the Camcorder from an AC OutletInserting Inserting and Removing a CassettePerform above, then take out the cassette Inserting and Removing a Card About the write-protect switchClose the card slot cover Installing Installing the Lithium BatteryTime Setting the DateT T I NG Attaching the Lens Hood Changing to the 12-hour Time ModeAttaching the Wrist Strap Press l or m to select 12H, then press the SET buttonAttach the strap to the lens cap as shown below Using the Lens CapHolding the camcorder Tips on Recording PositionsBasic posture Shooting from a high angleTAPE-CAMERA mode TAPE-VCR mode Selecting the Camcorder ModeCARD-CAMERA mode CARD-VCR mode Camcorder modesTo turn the power off Easy Camera Recording on Tape in Full Auto ModeTo pause recording Press the REC START/STOP button to begin recordingMacro Shots Zooming Auto FocusBasic Operations Camera Recording ZoomingRemaining Recording Time Display Remaining Battery Power DisplayTape Playback Using Earphones Commercially AvailableTo stop playback Still Volume ControlVideo Search Searching for a Scene Near the Current Tape PositionBasic Operations Playback Watching Playback on aTo turn off the menu screen Using the Menu ScreensPress the Menu button ExampleGU I DE Displaying Recording GuideTypes Turning on the recording guideTo use optical zoom only Setting the Digital ZoomSelect OFF in above Press lor mto select 40 or 300, then press the SET buttonTo cancel Gamma Brightness Compen- sation Useful features Camera RecordingGamma Brightness Compensation To obtain a brighter picturePress the GAMMA/BRIGHTER button again Eindicator appears To cancel the gain-up functionGain-up To cancel Fade mode UsingFade In and Fade Out To use Fade Out onlyEdit Search Quick ReturnRecording Standby Mode, press and holdStill Recording on Tape To cancel the still imageAttaching the Supplied Tripod Adapter To pause recordingWide Screen To cancel DIS functionDigital Image Stabilization DIS To return to normal screenMore Information on Self Re- cording Self RecordingTo return to SP mode Recording in LP Long Play Recording ModeAP E SP E E D LP Press l or m to select LP, then press the SET buttonTo return to 12-bit audio recording mode Selecting the 16-bit Audio Recording ModePress l or m to select 16bit, then press the SET button Select 12bit in aboveInstalling the Batteries Using the Remote ControlRemo T E on ActivatingDisplaying the Date and Time of Recording Useful Features PlaybackSlow S P L AYGamma Playback To cancel Gamma PlaybackCopying an Image from Tape to Card Gamma Playback has no effect during still playbackPicture Effect Playback To cancel Picture Effect PlaybackPress l or m to select the desired Picture effect, then press the SETManual Focus To return to Auto Focus modeTo return to Auto Exposure mode Advanced Features Camera RecordingManual Exposure Screen is displayedTo return to Auto White Balance mode Setting the Camcorder to Full Auto modeWhite Balance Lock Digital Picture Effects To cancel the digital picture effectScene settings cannot be used when displaying a still image To cancel the scene settingScene Menu Program AE SC E NE Menu SportOU T Using the Time CodeDisplay format Displaying the time code on a TV during playbackCutting Unwanted Sequences EditingTo stop editing RecordingRecording from an External Source Advanced Features PlaybackTo Record from an External Source To stop recordingL G D G T L O N Using the Camcorder as a ConverterTo DV terminal Digital equipmentTerminal IEEE1394 Editing with the DVTo Record from Video Equip MentAUD I O Selecting the Audio Playback ModeYou can select any of the following audio playback modes Normal recording mode Audio Dubbing FeatureAudio Dubbing mode Audio RecordingAudio Dubbing To cancel audio dubbingTo pause audio dubbing Press the Menu button. The audio dubbing screen disappearsPress the Still button fully to begin recording Selecting the Picture Quality Picture quality Approx. number SettingDigital Still Camera Features Card Recording TimerRecording with the Self Formatting a Card Available Operations during Full-screen Display Card PlaybackPress j, k, l or m on the Operation Button to move the selection frame toDelete Protection To cancel the protection set- tingDeleting Stored Images Digital Still Camera Features PlaybackDeleting One Stored Image Press j, k, l or m to select the image to be deletedDeleting All Stored Images About Dpof Print OrderAssigning Print Order to an Image To cancel the print order for all images To cancel the print order for an imageAssigning Print Order to All Images Transferring Data on Installing the USB driverCard to Computer System RequirementsImage Folders and File Names Disconnecting the USB cableWindows ME Windows XPTo stop Slide Show Playback Slide Show PlaybackPress l or m to select Slide Show Adjusting the Picture Picture/Backlight AdjustmentsAdjusting the Backlight Appendix Turning off Confirmation SoundPress l or m to select OFF, then press the SET button Useful Information Use a wide-angle setting for fast-moving subjectsHints for Better Shooting LightingSD Memory Card MultiMediaCard Appendix DV TechnologyDV and conventional video cassette tapes Mini DV Cassette Precautions when using a Mini DV cassetteCopyright Protection To protect recordings against acciden- tal erasureAppendix MultiMediaCard Precautions on handling MultiMediaCardsWatch out for static electricity Watch out for condensationSD Memory Card AC Adapter Precautions on handling SD Memory CardsReplacing the Fluorescent Lamp Protecting your dataThis camcorder uses a lithium-ion type battery pack Appendix Battery PackCharging StorageAC Adapter Supplied Accessory Cleaning Using Your Camcorder AbroadDemo Mode of F Demonstration ModeCancelling Demo Mode EMO MOD E onPower Before Requesting ServiceCard Specifications are subject to change without notice SpecificationsCamcorder AC Adapter UADP-0342TAZZ