Sharp VL-NZ100S manual Editing with the DV, Terminal IEEE1394, To Record from Video Equip, Ment

Advanced Features

Playback

Editing with the DV	To Record from Video Equip-
Terminal (IEEE1394)	ment
	1 Set the camcorder to TAPE-VCR mode,

Available mode:	and insert a Mini DV cassette.
TAPE-VCR

Advanced Features

51

This camcorder enables you to perform digital video editing. Connect the camcorder to video equipment with a DV terminal using a commer- cially available DV cable. A DV cable is able to transfer all dubbing signals including video and audio.

To Record to Video Equipment

See “Cutting Unwanted Sequences” on page 48, using the video equipment as the recording source.

Note:

•Make sure that the video equipment to which you are recording can input dubbing signals via the DV terminal.

To DV terminal	Video equipment
	with DV terminal
	(e.g. DV camcorder)

DV cable (commercially available)

To DV terminal

2 Begin playback on the video equipment connected to the camcorder.

•Check the camcorder screen to see if the picture is properly received.

3 Press the REC START/STOP button on the camcorder.

•The camcorder enters Recording Standby mode.

4 Press m on the Operation button to begin recording.

To stop recording

Press l on the Operation button.

Cutting Unwanted Sequences

1 Press m to pause recording when the source tape reaches the beginning of the sequence to be cut.

2 Press m to resume recording when the

source tape reaches the end of the sequence to be cut.

Notes:

•Make sure that the video equipment from which you are recording can output dubbing signals via the DV terminal.

•If the video equipment is not set to playback mode or the DV cable is not properly connected, “NO SIGNAL” is displayed on the camcorder screen.

•If no picture or sound is input to the camcorder even if the DV cable is properly connected and you are playing back the source media from the video equipment, set the Power switch on the camcorder to OFF and then back to VCR, or disconnect the DV cable and connect it again.

•If a digital video recording with a copyright protection signal is used as the playback source, “COPYRIGHT PROTECTED.” appears on the camcorder monitor and the recording function is disabled (see page 72).

•When displaying the playback picture on the recording equipment, you may find black bands around the image. This is caused by the differences of the image display sizes.

•You cannot output the picture playing back from the DV terminal to an external monitor.

VL-NZ100H-047-054 51 02.2.14, 10:02 AM