Ricoh IS450 operating instructions Initializing the Scanner

Page 30

2. Setting up the Scanner

Initializing the Scanner

If the SCSI ID rotary switch or DIP switch settings have been changed while the power is on, it is necessary to initialize the scanner in order to put the new settings into effect. To initialize the scanner, either turn the power off and then back on again, or else perform the procedure described below:

AUsing an object with a thin tip, such as a ballpoint pen, press the reset switch located on the back of the scanner.

Doing so puts the scanner into the same state as if the power had been turned off and then back on again.

16

Image 30

Contents Image Scanner Introduction Copyright Declaration of Conformity Safety Information Safety During OperationExamples of Indications Safety Information Iii Important Information Important InformationImportant Information Limitation How to Read This ManualHow to Read This Manual ReferenceTable of Contents Setting Originals OriginalsGeneral Scanning Method Manual Scanning DIP Switches Functions MaintenanceSpecifications OptionsPage Features IntroductionSpace-saving design IntroductionGuide to the Scanner Scsi Connector Power ConnectorRotary Switch DIP SwitchesUnderstanding the Indicators DescriptionIntroduction Preparing for Installation Setup locationChecking the Scanner Location Setting up the Scanner Installation space Installation environment ImportantUsable range Recommended range Setting up the Scanner Connecting to the Host ComputerWhat is SCSI? Scsi Connection Require Ments for the ScannerSetting the Scsi ID Connecting the Scsi Cable No Connection to Other PortConnecting to the Host Computer Connecting the Scsi Cable Connection to Other Port Connecting the Power Cable Plug the other end of the power cable into the power outlet Turning On/Off the Scanner Power Turning On the Scanner PowerTurning Off the Scanner Power Initializing the Scanner Recommended Sizes and Weights of Originals OriginalsDifficult to Detect Sizes Original Sizes and Scanning Area Originals Original sizes that can be detected automaticallyContact glass Auto Document Feeder ADF Setting Originals Setting the Original on the Contact GlassSetting the Original in the Auto Document Feeder ADF Align the originals on the ADFSimplex scanning Duplex scanning Guides Make sure the Auto Document Feeder ADF is closed Setting Originals Scanning Originals General Scanning MethodManual Scanning Scanning OriginalsWhen Scanning Does not Start Item to check ActionError Indicators and Solutions TroubleshootingDescription of error Action Procedures to Correct Errors in the ADF When an Original is Jammed in the Auto Document Feeder ADFReplacing the Ink Ribbon Do not pull on the Endorser’s cord Cleaning the Endorser Maintenance Cleaning the ScannerCleaning the Feed Roller and Drum AppendicesMaintenance Cleaning the White Roller Duplex Model Only Maintenance Moving the Scanner Disposing of the Scanner Carrying the Scanner a Short DistanceOptions Image Processing Unit Type aRed Lamp Unit Type a Endorser Unit Type a Printing Function Specifications Scanner Electrical and Hardware SpecificationsDIP Switches Functions PreviewBinary scanning ScanScanning Composition Halftone scanningStandard mode Dynamic threshold modeBinary Scanning/Threshold Halftone Scanning Gray Scale Scanning Area Extraction Section Area Multi-area Settings Auto Photo/Letter Resolution Brightness ContrastGamma Correction Noise removal Binary FiltersParameter Download SmoothingDocument Size Detection Document Size Detection on the Contact GlassDocument Size Detection in the Auto Document Feeder ADF When Erase Background is disabled When Erase Background is enabledErase Background DIP Switch 10, 27 IndexRed Lamp Unit Appendices