SMC Networks None manual Static IP Address Setting

`

IP CAM User’ Guide

Pan/Tilt IP Surveillance Camera

Figure 2

Step 1. Click Update. You can see 255DN-16023. Step 2. Click 255DN-16023. You can see

Name : DN-16023

IP : 192.168.9.1

SubMask ：255.255.255.0

GateWay ：192.168.9.254

HTTP Port：Http communication port. The default setting is 80.

UDP Port : UDPport, Per-seting is 1500 Step 3. Make sure the IP setting is STATIC.

Step 4. Double click on 255DN-16023 to open the browser. Type ID/Password to access into network monitoring screen (for detailed information, please refer to 3.1). If you can see the image screen, it means

2.3 HOW TO SET UP IP CAM

Before you set up IP CAM, you have to know the network environment and if the IP address is fixed or float that provided by your ISP. If you do not know, please contact with your ISP. Section 2.5 will list the common network structure (1 ~ 7 types). Users can refer to the structure to find out what type is suitable for his/her computer and finish the setting up according to the instructions. To set up IP-CAM and IP address, the common way that people use is to change the obtaining of IP address of IP-CAM. Detailed information is listed as 2.4-1 ~ 2.4.3.

2.4SETTING THE WAY TO OBTAIN THE IP ADDRESS OF IP-CAM

2.4-1 STATIC - IP Address Setting

•You computer must be equipped with network card and RT-45 network connector.

•Connect the RJ-45 terminator on the rear of IP-CAM to the red test network cable. One end is connected to the network card of computer; the other end is connected to the rear side of the IP-CAM.

•Connect the power adaptor to the power port (on the rear) of IP-CAM. Now, the status LED on the top of IP-CAM will light up.

IP CAM USER’S GUIDE PAGE 10/57 Rev. PV1.0