SMC Networks None manual IP-CAM Network Framework Installation

`

IP CAM User’ Guide

Pan/Tilt IP Surveillance Camera

2.5IP-CAM NETWORK FRAMEWORK INSTALLATION

：. IP-CAM Network Framework Installation 1

Way to access Internet	Use Permanent ADSL or Cable Modem
Physical IP Address	Owns several physical IP addresses
IP Share or LAN Hub	General model is OK.
Network Setup for IP -CAM	LAN Enable / Manually
Suitable Objects	Users with several physical fixed IP
	addresses and several IP-CAMs installed

1.Connect the RJ-45 terminator on the rear of IP-CAM to the red test network cable. One end is connected to the network card of computer; the other end is connected to the rear side of the IP-CAM.

2.Refer to 2.4-1 STATIC –IP Address Settings to type the IP address properly.

3.Set a physical IP address for each IP-CAM.

4.Set up the IP-CAM with fixed IP address.

5.For viewing images in IP-CAM from remote computer: Open IP browser and type

in the physical IP address of the IP-CAM, e.g., http://211.78.174.03.

IP CAM USER’S GUIDE PAGE 16/57 Rev. PV1.0