If the infrared detector on the unit is not labeled, follow these steps:
1Refer to the owner’s manual of your cable box or satellite receiver. It may be shown there.
2Look for an area of dark, nearly opaque plastic on the front of the unit. If you find this area, look closely into it. You may be able to see the infrared detector behind it. If it is visible, you should see a small square frame with a reddish area in the center. This is the infrared detector. Skip to “Connect and affix the IR blaster.”
3Shine a flashlight through the dark plastic area on the front of the unit. If you see the infrared detector, skip to “Connect and affix the IR blaster.”
4Using the remote control for your cable box or satellite receiver, turn the power on and off. Do not use the ReplayTV remote control.
5With the remote control in one hand, place the other hand over one section of the front of the unit.
6Try to turn the power on and off. If you succeed, your hand is not covering the infrared detec- tor.
7Move your hand to a different place on the front of the unit and repeat steps 5 and 6. Keep repeating in this manner until you cannot turn the power on and off. At this point, your hand is covering the infrared detector.
1 PlugConnectthe IRandblasteraffixtheinto | IRBLASTERblaster | connector on the back of ReplayTV. |
2Peel off the protective cover from one of the emitters on the IR blaster. This will expose the
adhesive material on | infrared emitter for placement onto your cable box or satellite |
receiver. |
|
3 Affix the adhesive side of the infrared emitter to the dark plastic area directly over the center Locating the infrared detector of the infrared detector.
•If you only want ReplayTV to control one device, hide the unused emitter behind the equipment, away from any detectors.
After you have connected IR blaster, you will need to provide ReplayTV with the setup code num- ber for your cable box or satellite receiver. You will do this during the
Affixing the IR blaster
gniteG