JVC TK-C1481 manual 22 Y/C OUT Y/C output connector, Video OUT Video signal output connector

	(			)		⁄
	+	-
	1	2	ISOLATEDPOWER ONLY (E TYPE)
DC12V	AC24V	CLASS2 ONLY(U TYPE)
			TX+ TX- RX+ RX- AUX GND
			A	B	C	D
fi						Y/C OUT
	SYNC IN	VIDEO OUT
›						SEE INST-
	POWER					RUCTION
						MANUAL
‹TK-C1480U and TK-C1480E

¤

fl

	TX+ TX- RX+ RX- AUX GND
	A B C D
	Y/C OUT
SYNC IN	VIDEO OUT
	SEE INST-
	RUCTION
POWER	MANUAL

TK-C1481EG

19[DC 12V, AC 24V] Power input terminals (TK-C1480U and TK-C1480E)

To input DC 12V or AC 24V power.

20[TX+A, TX-B, RX+C, RX-D] Control signal connection terminals Terminals for inputting signals with electrical characteristics conforming to the EIA/TIA RS-422A or RS-485 standard.  17 RX.TERM switch

21[AUX, GND] Auxiliary OutputTerminals If any change occurs in the area that was set on the MOTION DETECT screen, these terminals output signals. ( Page 31)

[Open-collector Low signal. Maximum voltage 30V, Current 30mA.]

22[Y/C OUT] Y/C output connector

This 4-pin connector outputs the luminance and chrominance signal.

• Pin configuration of Y/C OUT connector

4	3
2	1
Pin No.	Signal

1GND

2GND

3Luminance (Y)

4Chrominance (C)

23 [VIDEO OUT] Video signal output connector

This BNC connector outputs a composite video signal. Connect this to the video input connector of a video monitor, switcher, etc.

24[POWER] Power indicator lamp

This lamp lights when power is supplied to the camera.

25[SYNC IN] Sync signal input connector This BNC connector accepts the input of an external sync signal such as a composite video (VBS) or black burst (BB) signal.

When a sync signal is input into this connector, the camera operation is automatically synchronized with the

external sync signal.

To terminate this connector at 75Ω, turn ON the EXT.TERM switch 14 .

26Power cable (TK-C1481EG)

Connect to the commercial AC230V outlet

E-11