JVC TK-C1481 manual RM-P2580 System,
System with up to 8 cameras

MONITOR screen

(example showing camera ID as “05”)

CONNECTION/INSTALLATION

RM-P2580 System

System with up to 8 cameras

Camera 1

Camera
TK-C1480	Control signal cable
	Video signal cable

MACHINE ID:1 (Menu screen)

RX TERM: OFF (switch)

Camera

AC24V

Power or

cable DC12V

Camera 2

MACHINE ID:2 (Menu screen)

RX TERM: OFF (switch)

Camera 8

MACHINE ID:8 (Menu screen)

RX TERM: ON (switch)

TK-C1480

AC24V or DC12V

Camera

TK-C1480

AC24V or DC12V

TO

CAMERA

TO CAMERA

TO CAMERA

POWER

Remote Control Unit	OFF
RM-P2580	AC INPUT

ON

ON

		•	•	•	•	•	CAM SW Time lapse VCR
							OUT
										VIDEO IN
			CAMERA
				SW		COM
		DATA I / O					SERIAL-1	SERIAL-2
		DATA I / O
							SERIAL-1	SERIAL-2
1	2	3	4	5	6	7	8			MONITOR
			VIDEO INPUT
								MONITOR	MONITOR	OUTPUT 2
									MONITOR
								MONITOR	OUTPUT
								OUTPUT	OUTPUT
								1	2
1	2	3	4	5	6	7	8
			VIDEO OUTPUT

MONITOR

OUTPUT 1

MONITOR

MONITOR

This is the connected example of the TK-C1480U or TK-C1480E.

When controlling with any system except the RM-P2580, execute proper settings using switches and menu screens according to the systems used. ( Page 14)

MEMO

•When operating a system using the RM-P2580, several cameras (up to 8) can be connected and used on one control signal cable. Consequently, an incorrect switch setting on just a single camera will cause the entire system to work incorrectly.

•Confirm switch settings on the screen as follows.

qConfirm that the image from the camera to be checked

is displayed on the monitor.

wTurn OFF and then ON the AC 24 V power to the camera to be checked.

eThe camera begins the initial operation and charac- ters similar to those shown in the illustration on the right appear on the monitor screen.

rConfirm that “DUPLEX” and “ID-□□” are displayed and that the ID number is the correct number (the number should be the same as the number of the VIDEO INPUT terminal to which the camera is con-

nected on the rear panel of the RM-P2580).

tIf wrong, set the camera ID again.

E-12

P R O T O C O L : D U P L E X I D - 0 5

“DUPLEX” should	The number shown in the
be displayed.	□□ part of ID-□□
	should be correct.