Back focus adjustment
Back focus adjustment
Be sure to make
Back focus adjusting ring
Tighten
Loosen |
| C |
BF | LO | |
|
|
Back focus fixing screw (M2.6)
Lens focus ring
•With a fixed-focus lens
If the focus can not be adjusted correctly by rotating the lens focus ring, adjust the back focus as follows.
1. Loosen the back focus locking screw by turning it counterclocckwise ( 
) with a screwdriver.
2. Shoot a pattern closely.
3. Turn the lens focus ring to .
4. Turn the back focus adjustment ring to focus at the best point.
5. Tighten the back focus locking screw by turning it clockwise ( 
).
MEMO
•LENS FOCUS ADJUSTMENT MODE
At the time of focus adjustment, press the button 
at the side of the unit for at least one second to open the lens iris and to fa- cilitate focusing. At this time, “LENS FOCUS ADJUSTMENT MODE” will be displayed on the monitor screen.
When the adjustment has been completed,
press one of the buttons 
to can- cel focus adjustment mode.
•Focus setting can differ on the color and on the black and white screen. Make adjust- ments so that the focus will come to the op- timum on both screens.
MEMO
When the subject is bright, the use of an ND filter permits more accurate
•With a zoom lens
If the image is out of focus when zooming (telephoto
1. Loosen the back focus locking screw by turning it counterclocckwise ( 
) with a screwdriver.
2. Shoot a comparatively dark scene with thin lines.
3. Set the lens to the maximum telephoto position, and adjust the lens focus.
4. Set the lens to the maximum
(Repeat steps 3. and 4. two or three times.)
5. Tighten the back focus locking screw by turning it clockwise ( 
).