JVC TK-C1481 Controls, Connectors and Indicators, Lens mount, Camera-mounting screw hole 1/4 inch

Page 8

INTRODUCTION

Controls, Connectors and Indicators

2

13

7 6

4

5

1Lens mount

This means to attach the lens.

This is applicable to both the C-mount lenses and CS-mount lenses.

2Backfocus adjustment ring Adjusting the back focus during lens installation.

When readjustment is required, loosen the locking screw 3 by turning it counterclockwise and turn the back focus adjustment ring 2 .

After the adjustment, tighten the locking screw 3 again.

3[BF LOCK] Back focus locking screw This serves to fix the back focus-adjusting ring.

4Camera-mounting bracket

The bracket has been attached on the bottom of the camera before shipment. It can also be attached on the top according to the circumstance.

To re-attach the bracket use the threaded holes at the top, with the camera mounting bracket locking screws 7 .

5Camera-mounting screw hole (1/4 inch)

Use this hole when mounting

 

the camera onto a fixer, pan/

MAX.

tilt unit, and the like. (Use a 7mm

screw shorter than 7 mm.)

 

6Rotation-preventive hole

Make use of this rotation-preventive hole to prevent any fall when mounting the camera. Make sure that the camera is securely mounted.

7Camera mounting bracket fixing screws (2: M2.6 6 mm)

Be sure to use a 6 mm long screw.

E-8

Image 8
Contents TK-C1480 TK-C1481 Important Safeguards Page Safety Precautions Contents  Reference page or item FeaturesMemo Operating Precautions Controls, Connectors and Indicators Lens mountCamera-mounting screw hole 1/4 inch Rotation-preventive holeVIDEO/DC Iris Selector Switch CoverIris Iris Terminal Menu Menu Button15 INT/GL, LL Selector Switch for Synchronizing System DUPLEX, Simplex Selector Switch for Transmission System17 RX.TERM-ON/OFF RX SignalTerminal ON/OFF Switch 13 , , , Up-and-down, left-and- right Button22 Y/C OUT Y/C output connector Video OUT Video signal output connectorPower Power indicator lamp Power cable TK-C1481EGRM-P2580 System  System with up to 8 cameras Connecting the control signal cable  Setting the switches  Setting on the Menu screen  When connectingProcedures Setting the switchesThis is the connected example of the TK-C1480U or TK-C1480E TK-C1481EG Mounting the lens DC Iris Video IrisVideo GNDTK-C1481EG AC230V  Power supplyConnections on the back  Control signal cables  Genlock connectionSpecified screw M3 ⋅ 6 mm Mounting the cameraFall Prevention Installation of camera Does not operate Lens adjustmentLevel adjustment Back focus adjustment  Back focus adjustmentLens Focus Adjustment Mode With a fixed-focus lensAuto white balance control adjustment Error message displaySetting the menu Menu screen is displayedSelected sub-menu screen is displayed Change of the set value displays a change mark ∗Flow of menu screen Word Colour is displayed as Color on the TK-C1480UTK-C1480U does not display these characters Functions and set values Initial value Sync Adjust ScreenALC Settings Screen Speed ShutterExDR Memo Priority MotionBLC OFFVideo Adjust Screen Mode Select Screen Motion Detect ScreenAlarm Time Area EditFactory Settings Screen Communication ScreenBLC Editting Screen Manual Adjustment of White Balance Camera Title Setting Screen returns to Mode SelectThen, the Camera Title screen is brought up Selected character is displayed flashing on and offSetting the Motion Detect Function Setting screen is brought upSelect the item Area Edit on Motion Detect screenDimensions Unit mm Installing the ferrite coreSpecifications OUT Composite video signal 1 V p-p, 75Ω BNCVideo OUT Colour Video Camera