JVC KY-F1030 manual Before shooting, Connecting through digital output connector, AC adapter, E15

2. Before shooting
Connecting through digital output connector
The KY-F1030 can be remote-controlled from a personal computer, and the shot image can be
shown on the computer’s monitor.
<Connection Example> Shooting with the camera when the flash is fired by the timing of an
external trigger switch.			AA-P700
Connect to the power supply
			AC ADAPTER AA-P700
( page E18)			POWER
			ON
			OFF	AC
	[IEEE1394]		AC adapter
	Connecting the IEEE 1394				Special application software
	Cable ( page E18)
					KY-LINK
[DC IN]
		[REMOTE]
					IEEE1394
FOCUS LOCK					host
					adapter
Attach lens					PC
( page E17)			Flash
			Trigger switch

1.Connect the KY-F1030’s [IEEE1394] connector to the IEEE1394 host adapter on the PC.

2.Connect the flash and trigger switch to the [REMOTE] terminal.

3.Turn on the power of the KY-F1030.

*The power for KY-F1030 can be supplied from the IEEE1394 connector of personal com- puter. However, be sure to use the AC adapter (AA-P700) when using the motorized lens or when using both analog output and digital output in combination.

4.Turn ON the PC, and then start up the special application software KY-LINK.

*For how to operate the application software, see the Help file of the KY-LINK.

CAUTION

●Do not turn the power switch on the AC adapter ON/OFF or unplug the IEEE1394 cable while the application software is running.

●Before using the computer with the KY-F1030, release any settings that automatically set the com- puter in the Stand by or Hibernate mode.

MEMO If two or more KY-F1030 cameras are connected to one computer, it is not possible to view the camera images simultaneously.

Connecting through analog output connector
The image shot by the KY-F1030 can be shown on the computer’s monitor.
Connect the power supply		AA-P700
			AC ADAPTER AA-P700
( page E18)			POWER
			ON	AC
			OFF
		AC adapter
[DC IN]	[ANALOG OUT]

		Video
FOCUS LOCK		capture
		board
	Microscope	PC
	adapter

1.Connect the KY-F1030’s [ANALOG OUT] connector to the PC’s capture board.

2.Connect the AC adapter (AA-P700) to the KY-F1030, and then turn ON the power.

3.Turn ON the PC.

*For instructions on how to operate the video capture board or the employed application

software, see the respective instruction manual.

CAUTION Use a 1/2-inch C-mount microscope adapter compatible with the microscope to be employed.

MEMO When the shutter speed becomes slower (slower than 1/7.5s), the image may be seen interrupted. Also, the image will not freeze even when the external trigger switch is pressed.

E14 E15