1. Introduction (continued) Cautionary notes for the correct usage of this product
• | Before recording an important event, etc., always check to make sure that this product is |
| working properly. |
• | We are not liable for any missed recordings caused by malfunction of this unit, etc. |
Phenomena unique to CCD | |
• | Smearing and blooming |
| When using CCD to shoot a bright light source, a smearing effect may occur running a |
| white line vertical to the light source. In addition, a blooming effect may also occur when the |
| light source is extremely bright, spreading light to the source surroundings. |
• | Line distortion |
| Line and patterns may appear distorted when shot. |
• | White spots |
| White spots may appear on the screen when operating under high temperatures. Always |
| use the product under recommended ambient temperatures. |
| White spots may also appear at a slow shutter speed setting (1/8 s or higher). |
| To reduce this phenomenon, this product is provided with at |
Part names and their functions
[Front and bottom]
| tion function. ( Z page E28 White spot compensation) |
Cautionary notes | |
• | Influence of strong electric waves and magnets |
| Screen noise and discolouration may occur when using the product near antennas of ra- |
| dios and televisions or near transformers, monitors, etc. with strong magnetic force. |
• | Compatible lenses ( page E17 Mounting the lens) |
| Although the lens mount of this product is a type C mount, take caution as there are restric- |
| tions on the lenses that can be used. |
• | To save electricity, turn off the system when not in use. |
Cleaning When clean the equipment please use dry cleaning cloth or wet cleaning cloth with small amount of alcohol. Do not spill any liquid into
Do not install the
Lens mount Although the lens mount conforms to the type C mount lens. Mounting the lens ( page E17)
Camera mounting bracket Although the mounting bracket is mounted on the bottom of the camera when shipped, the bracket can also be mounted on the top of the camera. Mounting the camera ( page E19)
Locking screws for the camera mounting bracket (M2.6 ⋅ 6mm, 3 units)
CAUTION
●Always use the attached screws. Using screws that exceed 6mm may result in mal- function of the unit.
●When the bracket is mounted on the top sur- face of the camera, use the provided screws (length: 10 mm).
Screw holes for mounting the camera
Side switch panel (inside) Open the door to access a switch panel used when making settings on menus. Side switch panel section ( page E11)
[FOCUS] backfocus adjustment screw This is adjusted to the optimal wide setting when shipped from the factory. Should be readjusted when required by the lens used in combination with the camera. Focus adjustment ( page E24)
[LOCK] backfocus locking screw Screw to lock the backfocus adjustment mechanism. Focus adjustment ( page E24)
E8
E9