JVC KY-F1030 manual Settings and adjustments for shooting, Lens settings, Auto

2. Before shooting (continued) Fall prevention

Fall prevention wire chain

Mounting screw dimen- sions: • When mounted on top: 10 mm • When mounted on un- derside: 6 mm

3. Settings and adjustments for shooting
Lens settings
Set according to whether the used lens to be used is an auto-iris lens or a manual lens.
	Set the used Lens
	Set the [IRIS MODE] on the [EXPOSURE] screen.
	( page E33)
	AUTO	: Setting when auto-iris lens is used in auto mode.
	MANUAL : Set when using a manual lens, using an auto-iris
		lens in MANUAL or no lens.

*If the auto-iris lens cable is not connected to the [LENS] connector, the setting automatically becomes “MANUAL”.

(Default setting: AUTO) Monitor adjustment

The colour contrast and brightness are adjusted whilst, built-in test signals of the camera are being displayed on the PC monitor.

MEMO

•Special attention is required when mounting the unit to the wall or ceiling. Rather than attempting to do it yourself, request a qualified person to perform such instal- lation. Falling of the unit may result in bodily injury.

•To prevent the unit from falling, connect the unit to a strong surface with a wire chain, etc. When connecting such chain, use the bracket locking screw hole on the side which the camera mounting bracket is not mounted.

•When mounted on top: M 2.6 ⋅ 10 mm (provided)

•When mounted on underside: M 2.6 ⋅ 6 mm

Take special caution to the length of the optional wire as well.

•For the fall-preventive wire, use the one with the strength that is more than 10 times of a mass including the lens.

[ANALOG OUT]	[IEEE1394]
ANALOG OUT	IEEE1394
LENS
	MD
	CONTROL
DC IN	REMOTE
POWER
SEE INSTRUCTION MANUAL

Inside window
	UP/AW
MENU	SET
	DOWN
1 2	3 4
Default Setting Switch

1.	Connect the [ANALOG OUT] connector or the
	[IEEE1394] connector to the PC.
2.	Set the function setting switch NO.1 on the switch panel
	on the side of the KY-F1030 to “ON”.
	ON
	OFF	2	3	4
	1
3.	Turn ON the KY-F1030, and then start the PC.

*When connecting through the [IEEE1394] connector, power is supplied from the PC.

4.	Adjust the monitor.
	MEMO

•For how to adjust, see the instructions for the employed monitor.

•The peak level of the test signal is set to 0.7V from the fac- tory. To use 0.57V, change the setting by [TEST PATTERN] ➝ [LEVEL] on the [SYSTEM SETTING] screen.

page E40 TEST PATTERN

E20 E21