2. Before shooting (continued)
Connecting power
Between the 8 pin DC IN terminal on the rear of the main unit and the 8 pin TO CAMERA terminal of the AC adapter
Mounting the camera |
< Mounting method > |
AC
| AC adapter |
|
| |
| DC 12V=OUTPUT | ANALOG OUT |
| |
|
| VIDEO OUTPUT | IEEE1394 | |
AC 100V |
|
|
|
|
|
|
| LENS |
|
| S(Y/C) OUTPUT | TO CAMERA |
|
|
|
|
|
| MD |
|
|
|
| CONTROL |
| EITHER | SEE INST- |
|
|
| OUTPUT | RUCTION | DC IN | REMOTE |
| MAX 1.25A | MANUAL | ||
|
|
| POWER |
|
White marking | [TO CAMERA] | SEE INSTRUCTION MANUAL |
connector |
| |
|
| |
| power cable | [DC IN] connector |
Connect the end with |
| |
the white marking to |
|
|
the AC adapter. | (provided) |
|
|
|
DC IN
POWER
Ring
Plug
After inserting the plug com- pletely, tighten the securing ring. Make sure white indication of power cable comes to AA- P700 side.
Rotation prevention hole | Camera mounting screw hole |
Camera mounting bracket
CAUTION
•Be sure to use the
Before connecting power cable, make sure that the power switch on the
•When connected through the digital output (Connecting through digital output connector (page E14)), power can be supplied from the PC but control of a motorized lens and analog output will not be possible.
MEMO
Wait at least 10 seconds before turning the power switch back on, when it has just been turned off. Turning the power switch on and off quickly may cause malfunctions, such as failure to boot, etc.
Connecting the IEEE1394 Cable
To reduce the emission of unwanted radio waves, make sure to attach the provided clamp filter as shown in the figure on the left. Attach the clamp filter as close to the
To [IEEE1394] connector
● When mounting the camera, use the camera mount screw hole located on the camera mount- ing bracket. ● When mounting the camera, use the rotation prevention hole to prevent the unit from falling and securely mount the unit.
< Changing the camera mounting bracket position >
When shipped, the camera mounting bracket is mounted on the bottom of the unit. To mount it on the top of the unit, simply remove the 3 locking screws holding the camera mounting bracket.
CAUTION • When the camera mounting bracket is mounted on the top surface of the camera, be sure to use the provided screws (length: 10 mm).
Mounting screw dimensions: • When mounted on top: 10 mm • When mounted on underside: 6 mm
E18 | E19 |