JVC TK-WD31 manual DC Iris Video Iris, Gnd

Page 21

1. Before mounting a lens, check whether it is CS-mount lens. Dimension (b) of the lens shown in the illustration must be as shown in the table below. If (b) exceeds the value in the table, it may dam- age the inside of the camera or correct mounting may be impos- sible; never use such lenses. The F mark indicates a focal point.

Lens

Flange back (c)

Dimension (b)

CS mount lens

12.5mm

5.5mm or less

 

 

 

*When using the C-mount lens, use the conversion ring (CM46633- 001, MOUNT ADAPTOR).

2.Attach the included ferrite core to the lens cable. Please attach it as close to the camera as possible.

3.Mount the lens on the camera by turning the lens clockwise. Adjust its position.

4.When using an auto-iris lens with an EE amplifier, turn the switch to the “VIDEO” side. When no EE amplifier is equipped, turn the switch to the “DC” side.

5.If the lens has an auto-iris mechanism, connect the lens cable after checking the pin arrangement.

If the lens cable has a different type of plug, use the 4-pin plug. [4-pin plug part no: SCV2859-001]

Contact your dealer of purchase concerning the 4-pin plug.

Lens

DC IRIS

 

VIDEO IRIS

Pin No.

(does not contain EE amplifier)

(contain EE amplifier)

1

Brake

9V [max 50mA]

2

Brake

+

NC

3

Drive

+

VIDEO

4

Drive

GND

 

 

 

 

15

Image 21
Contents LWT0181-001B-H Color Video Camera TK-WD310INSTRUCTIONSImportant Safeguards Page III Page Safety Precautions Page Introduction Features Reference page or item MemoContents Operating Precautions Introduction Page Backfocus adjustment ring Names and Operations of PartsFront and Bottom Lens mount Camera-mounting bracket Use a screw shorter than 7 mm.Rotation prevention hole Power Power indicator lamp Video OUT Video signal output connectorThis lamp lights when power is supplied to the camera Rear PanelSET button Selector buttonThis is set for internal synchronization INT Side Panel VIDEO/DC Iris Selector SwitchIris Iris Terminal This is connected to an automatic iris control lens.System with up to 8 cameras Basic SystemMounting the lens Mount the lens according to the procedures described belowDC Iris Video Iris VideoGND Connections on the back Power supply DC 12 V or AC 24Conductor diameter Φmm More 100 m 260 m 410 m 500 m ReferenceMounting the camera Fall Prevention Auto iris lens adjustment Level turning direction Level adjustmentToo bright Too dark Clockwise Toward HBack focus adjustment With a zoom lens With a fixed-focus lensOperation Menu settingsC M OD E Menu screens are structured as shown below Menu treeDefault setting OFF Focus Adjust screenAbout menus ModeWDR Mode Video Adjust screenWDR Mode Wide Dynamic Range WDR is adjusted manuallyWDR Bias ContentWDR Limit EXP. BiasSetting Gain AGC ModeMemo White Balance Default setting ATWPreparation ManualThis setting is performed when using the DC auto iris lens Camera Settings screenColor Level Enhance LevelCamera Title PhaseDC Gain DC OffsetRepeat steps 4. and 5. above to enter up to 24 characters Camera Title Edit screen Allowed characters Factory Settings screen Returns set values to their factory settingsClear Symptom Remedy TroubleshootingOperation becomes un Ultra Super High MID LOW OFF MAX MINVideo OUT SpecificationsLx 50%, F1.2, AGC High Lx 50%, F1.2, AGC ULTRA⋅16TK-WD310 Color Video Camera