JVC TK-WD31 manual Iii

Page 4

13.Follow all warnings and instructions marked on the appliance.

14.Do not overload wall outlets and extension cords as this can result in fire or electric shock.

15.Never push objects of any kind into this appliance through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance.

16.Do not attempt to service this appliance yourself as opening or re- moving covers may expose you to dangerous voltage or other haz- ards. Refer all servicing to qualified service personnel.

17.Unplug this appliance from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power cord or plug is damaged or frayed.

b.If liquid has been spilled into the appliance.

c.If the appliance has been exposed to rain or water.

d.If the appliance does not operate normally by following the oper- ating instructions. Adjust only those controls that are covered by the operating instructions as improper adjustment of other con- trols may result in damage and will often require extensive work by a qualified technician to restore the appliance to normal op- eration.

e.If the appliance has been dropped or the cabinet has been dam- aged.

f.When the appliance exhibits a distinct change in performance - this indicates a need for service.

III

Image 4
Contents Color Video Camera TK-WD310INSTRUCTIONS LWT0181-001B-HImportant Safeguards Page III Page Safety Precautions Page Features IntroductionMemo  Reference page or itemContents Operating Precautions Introduction Page Names and Operations of Parts Backfocus adjustment ringFront and Bottom Lens mount Use a screw shorter than 7 mm. Camera-mounting bracketRotation prevention hole Video OUT Video signal output connector Power Power indicator lampThis lamp lights when power is supplied to the camera Rear PanelSelector button SET buttonThis is set for internal synchronization INT VIDEO/DC Iris Selector Switch Side PanelIris Iris Terminal This is connected to an automatic iris control lens.Basic System System with up to 8 camerasMount the lens according to the procedures described below Mounting the lensVideo DC Iris Video IrisGND Power supply DC 12 V or AC 24 Connections on the back100 m 260 m 410 m 500 m Reference Conductor diameter Φmm MoreMounting the camera Fall Prevention Auto iris lens adjustment Level adjustment Level turning directionToo bright Too dark Clockwise Toward HBack focus adjustment With a fixed-focus lens With a zoom lensMenu settings OperationC M OD E Menu tree Menu screens are structured as shown belowFocus Adjust screen Default setting OFFAbout menus ModeVideo Adjust screen WDR ModeWide Dynamic Range WDR is adjusted manually WDR ModeContent WDR BiasWDR Limit EXP. BiasAGC Mode Setting GainMemo Default setting ATW White BalanceManual PreparationCamera Settings screen This setting is performed when using the DC auto iris lensColor Level Enhance LevelPhase Camera TitleDC Gain DC OffsetCamera Title Edit screen Repeat steps 4. and 5. above to enter up to 24 characters Allowed characters Returns set values to their factory settings Factory Settings screenClear Troubleshooting Symptom RemedyOperation becomes un Ultra Super High MID LOW OFF MAX MINSpecifications Video OUTLx 50%, F1.2, AGC High Lx 50%, F1.2, AGC ULTRA⋅16TK-WD310 Color Video Camera