JVC TK-WD31 manual Fall Prevention

Page 25

SEE INST-		DC12V
RUCTION		AC24V	1	2
MANUAL
CLASS 2 ONLY (UTYPE)
ISOLATED POWER ONLY
		(ETYPE)
POWER	VIDEO OUT		SET	SELECTOR
POWER	VIDEO OUT
LL	INT

6mm

2mm

M3 ⋅ 6

Fall Prevention

•Exercise maximum caution when installing the unit to the wall or ceiling. You should not engage in the installation work yourself. Ask a professional to do the job, since the fall of the unit can result in injuries and accidents.

•When installing the unit on a fixer, Pan/Tilt unit, etc., make sure to install it firmly using a rotation-preventing hole provided to prevent fall.

•To prevent fall, connect the unit to a section with sufficient strength (ceiling slab or channel) using a fall prevention wire such as a wire chain and the like. Use the black screw on the back of the unit for installation.

For the used safety cable, pay particular caution to the length, strength, pull, material (insulation), etc.

•Specified screw (M3 ⋅ 6 mm)

Never use any screw longer than the specified length as the inside can be damaged.

19

Image 25

Contents LWT0181-001B-H Color Video Camera TK-WD310INSTRUCTIONSImportant Safeguards Page III Page Safety Precautions Page Introduction Features Reference page or item MemoContents Operating Precautions Introduction Page Names and Operations of Parts Backfocus adjustment ringFront and Bottom Lens mount Use a screw shorter than 7 mm. Camera-mounting bracketRotation prevention hole Power Power indicator lamp Video OUT Video signal output connectorThis lamp lights when power is supplied to the camera Rear PanelSelector button SET buttonThis is set for internal synchronization INT Side Panel VIDEO/DC Iris Selector SwitchIris Iris Terminal This is connected to an automatic iris control lens.System with up to 8 cameras Basic SystemMounting the lens Mount the lens according to the procedures described belowVideo DC Iris Video IrisGND Connections on the back Power supply DC 12 V or AC 24Conductor diameter Φmm More 100 m 260 m 410 m 500 m ReferenceMounting the camera Fall Prevention Auto iris lens adjustment Level turning direction Level adjustmentToo bright Too dark Clockwise Toward HBack focus adjustment With a zoom lens With a fixed-focus lensOperation Menu settingsC M OD E Menu screens are structured as shown below Menu treeDefault setting OFF Focus Adjust screenAbout menus ModeWDR Mode Video Adjust screenWDR Mode Wide Dynamic Range WDR is adjusted manuallyWDR Bias ContentWDR Limit EXP. BiasSetting Gain AGC ModeMemo White Balance Default setting ATWPreparation ManualThis setting is performed when using the DC auto iris lens Camera Settings screenColor Level Enhance LevelCamera Title PhaseDC Gain DC OffsetRepeat steps 4. and 5. above to enter up to 24 characters Camera Title Edit screen Allowed characters Returns set values to their factory settings Factory Settings screenClear Symptom Remedy TroubleshootingOperation becomes un Ultra Super High MID LOW OFF MAX MINVideo OUT SpecificationsLx 50%, F1.2, AGC High Lx 50%, F1.2, AGC ULTRA⋅16TK-WD310 Color Video Camera