JVC TK-WD31 manual Introduction, Features

Page 8

INTRODUCTION

Thank you for purchasing this product.

(These instrustions are for TK-WD310U and TK-WD310E.)

Before beginning to operate this unit, please read the instruction manual carefully in order to make sure that the best possible per- formance is obtained.

Features

Backlight compensation over a wide area is realized by the 14-bit Wide Dynamic Range feature.

The Wide Dynamic Range feature controls the exposure time using a maximum of 5 sampling timing for the image within a single screen. Even when shooting in areas with large difference in lightning, sub- jects with difference in brightness can be viewed in a clear and natu- ral state.

1/3-inch high-resolution DPS device adopted as shooting element to realize high picture quality with no smearing or blooming in areas with high luminance. In addition, 1.9lx (during F1.2, 50%, AGC HIGH setting) is realized for minimum subject brightness.

Horizontal resolution of 480 lines (typ.) and vertical resolution of over 400 lines allow display of finely detailed video.

New device adopted for use even under strong electric field condi- tions.

Compatible with CS mount and VIDEO auto iris/DC auto iris. * When using the C mount lens, C mount adapter is required.

Various settings in each menu screen are possible.

Menu settings can be performed easily using single button opera- tions.

3 white balance modes of ATW, AWB and MANUAL are available. ATW mode that adjusts the white balance automatically according to the changes in lighting conditions (color temperature) or AWB/ MANUAL mode that automatically or manually adjusts and locks the white balance of specific lighting conditions can be selected.

Camera title setting and display can be made.

Compact design allows installation in narrow spaces.

2

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Color Video Camera TK-WD310INSTRUCTIONS LWT0181-001B-HImportant Safeguards Page III Page Safety Precautions Page Features IntroductionMemo  Reference page or itemContents Operating Precautions Introduction Page Front and Bottom Lens mount Backfocus adjustment ringNames and Operations of Parts Rotation prevention hole Camera-mounting bracketUse a screw shorter than 7 mm. Video OUT Video signal output connector Power Power indicator lampThis lamp lights when power is supplied to the camera Rear PanelThis is set for internal synchronization INT SET buttonSelector button VIDEO/DC Iris Selector Switch Side PanelIris Iris Terminal This is connected to an automatic iris control lens.Basic System System with up to 8 camerasMount the lens according to the procedures described below Mounting the lensGND DC Iris Video IrisVideo Power supply DC 12 V or AC 24 Connections on the back100 m 260 m 410 m 500 m Reference Conductor diameter Φmm MoreMounting the camera Fall Prevention Auto iris lens adjustment Level adjustment Level turning directionToo bright Too dark Clockwise Toward HBack focus adjustment With a fixed-focus lens With a zoom lensMenu settings OperationC M OD E Menu tree Menu screens are structured as shown belowFocus Adjust screen Default setting OFFAbout menus ModeVideo Adjust screen WDR ModeWide Dynamic Range WDR is adjusted manually WDR ModeContent WDR BiasWDR Limit EXP. BiasAGC Mode Setting GainMemo Default setting ATW White BalanceManual PreparationCamera Settings screen This setting is performed when using the DC auto iris lensColor Level Enhance LevelPhase Camera TitleDC Gain DC OffsetCamera Title Edit screen Repeat steps 4. and 5. above to enter up to 24 characters Allowed characters Clear Factory Settings screenReturns set values to their factory settings Troubleshooting Symptom RemedyOperation becomes un Ultra Super High MID LOW OFF MAX MINSpecifications Video OUTLx 50%, F1.2, AGC High Lx 50%, F1.2, AGC ULTRA⋅16TK-WD310 Color Video Camera
Top Page Image Contents