JVC GR-AXM700 Select Still Image, Begin Insert Editing, END Insert Editing, Button Power Switch

EN71

COUNTER R/M

REW	PLAY/PAUSE
	FF
STOP

Insert Editing (Insert A Still Image From The Built-in Memory Onto A Tape)

You can insert a still image stored in the camcorder's built-in memory into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

Perform steps 1 through 5 in Insert Editing (☞ pg. 70) before the following procedure.

Page Button

	Power Switch
	Insert editing
	indicator
M–0:12:34	Tape Counter

LCD monitor or viewfinder

System Select

Switch

START/STOP

REW

PLAY

PAUSE

REW

INSERT

RM-V700URM-V705U

(optional) OR (provided)

NOTE:

Use the RM-V705U or RM-V700U remote control unit to perform this procedure.

SELECT STILL IMAGE

1 First set the System Select Switch to “D.S.C.”. Press the Page Button to select the still image you wish to insert.

BEGIN INSERT EDITING

2 Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

To insert still images in sequential order onto the tape . . .

.... press the Page Button to move the page forward.

To insert still images at random onto the tape . . .

.... first record the still image you selected in step 1

onto the tape, then press START/STOP to engage the Insert-Pause mode. To select another still image, press the Page Button again, then press START/STOP. Insert-Editing begins.

END INSERT EDITING

3 Press STOP.

NOTES:

●When Insert Editing is performed with the LCD monitor fully opened, the original audio will be heard from the speaker.

●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

●Only video signal is recorded in the Insert Editing mode.