JVC GR-AXM700 20 EN, Power Switch Start/Stop Button, Lights while recording Switch Is in progress

20EN

VIDEORECORDINGBasicRecording(cont.) Shooting while watching the LCD monitor

180° 90° Before the following steps, perform step 1 (☞ pg. 18).

ENTER RECORD–STANDBY MODE

2 Make sure the LCD monitor is fully open. Slide the LENS COVER Open/Close Switch to open the lens cover. Set the System Select Switch to “VIDEO”, then set the Power Switch to “CAMERA”.

LENS COVER Switch	•The power indicator lights and the camcorder
	enters the Record–Standby mode.
	•The scene you’re aimed at appears in the LCD
	monitor, with the word “PAUSE” superimposed
	upon it.

Power

Switch

Start/Stop Button

Power indicator

START SHOOTING

3 Tilt the LCD monitor upward/downward for best viewability (☞ pg. 21) and press the Recording Start/Stop button.

•“REC ” appears in the LCD monitor while recording is in progress.

STOP RECORDING

4 Press the Recording Start/Stop Button again to stop recording.

•The camcorder re-enters the Record-Standby mode.

Tally lamp	System Select
(lights while recording	Switch
is in progress)

NOTES:

●When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this

happens, we recommend that you use the viewfinder (☞ pg. 18).

●The tape remaining time is not displayed on the LCD monitor. However, when the tape is about to reach its end, the following indicators appear:

“ 2MIN” ´“ 1MIN” ´“ 0MIN”.

●For other notes, refer to pg. 19.