JVC GR-AXM700 manual Recording cannot be performed, Hole with adhesive tape pg, Playback picture

					EN	81
When the System Select Switch is set to “VIDEO”:
		SYMPTOM		POSSIBLE CAUSE(S)
	RECORDING
	Recording cannot be performed.		● Make sure the Erase Protection tab is in the position that
			allows recording. If not, slide the tab. Some cassettes have
			removable tabs. If the tab has been removed, cover the
			hole with adhesive tape (☞ pg. 17).
			● If the System Select Switch is set to “D.S.C.”, it is not
			possible to record onto the tape. Change the Switch
			position to “VIDEO” (☞ pg. 18).
	Recording does not start.		● The camcorder Power Switch has not been set to
			“CAMERA” (☞ pg. 18).
	PLAYBACK
	The tape is running, but there’s no		● The TV has not been set to its VIDEO mode or channel.
	playback picture.		● If A/V connection is used, the TV’s VIDEO/TV Switch has
			not been set to VIDEO.
			● The RF unit has not been set to the correct channel.
	Playback cannot be performed.		● If the System Select Switch is set to “D.S.C.”, it is not
			possible to play back a tape. Change the Switch position
			to “VIDEO” (☞ pg. 42).
	Playback picture is blurred or		● The video heads are dirty or worn out. Consult your
	interrupted.		nearest JVC dealer for head cleaning or replacement.
	The counter indication is blurred		● This is normal.
	during Still playback.
	TAPE TRANSPORT
	The tape stops during fast-forward		● The Counter Memory Function has been activated
	or rewind.		(☞ pg. 44).
	Rewinding or fast-forwarding cannot		● The tape is already fully wound on one reel or the other.
	be performed.
	OTHER
	The picture is blurred in the Quick		● This is normal while recording in the EP mode. Some noise
	Review or Retake mode.		may be present while recording in the SP mode (☞ pg. 16).
	The date and time displays		● If you remove the power source from the camcorder while
	disappear.		the power is on, all settings and selections are erased. Make
			sure to turn the camcorder’s power off before disconnecting
			the power source.
	The wrong date and time are		● If you have not performed Date/Time Setting (☞ pg. 13),
	displayed/recorded.		the date and time are not displayed/recorded correctly. Be
			sure that Date/Time setting is carried out.
	The tape won’t eject.		● The battery pack is running low.
			● If the LCD monitor is not open over 45 degrees, EJECT
			switch does not function.