JVC GR-AXM700 manual 80 EN, No power is supplied, Some functions are not available

80EN

TROUBLESHOOTING

SYMPTOM

POWER

No power is supplied.

The power suddenly goes off and doesn’t come back on by itself.

OTHER

POSSIBLE CAUSE(S)

●The battery pack has not been attached correctly (☞ pg. 10).

●The battery pack is not charged (☞ pg. 10).

●The power supply has not been correctly connected (☞ pg. 11).

●The battery pack has completely discharged.

●Remove the cassette and disconnect the power source, then after a few minutes, try turning the power back on. If it still doesn’t come on, consult your nearest JVC dealer.

Some functions are not available.

Vertical white lines appear when shooting a very bright object.

Bright, crystal-shaped spots appear in the LCD monitor and the viewfinder.

The rear of the LCD monitor is hot.

Colored bright spots appear all over the LCD monitor.

The indicators and the picture color on the LCD monitor are not clear.

The LCD monitor, the viewfinder and the lens have become dirty (ex. fingerprints).

An error number (i.e. E03) appears.

The image is out of focus.

Even though the Lens Cover is open, the Lens Cover Warning indicator blinks.

●The Select Dial is set to “AUTO LOCK”.

●This sometimes occurs when the contrast between the background and the object is great. It is not a defect of the camcorder.

●Sunlight is directly entering the lens. This is not a defect of the camcorder.

●The light used to illuminate the LCD monitor causes it to be hot. Close the LCD monitor to turn it off or set the Power Switch to OFF, and let the unit cool down.

●The LCD monitor is made with high-precision technology. However, black spots or bright spots of light (red, green or blue) may appear constantly on the LCD monitor. These spots are not recorded on the tape. This is not due to any defect of the unit. (Effective dots: more than 99.99 %.)

●This may occur when the surface or the edge of the LCD monitor is pressed.

●Wipe them gently with soft cloth. Gently wipe the LCD monitor in a semicircle because wiping strongly spreads the stain and it won’t come out easily.

●Turn the camcorder’s power off, then disconnect the power source. After a few minutes, try turning the power on again. If the error number still appears, consult your nearest JVC dealer.

●The diopter needs to be adjusted (☞ pg. 14).

●The scene being shot is adversely affecting the operation of Auto Focus (☞ pg. 36).

●The Lens Cover Warning indicator may blink when the camcorder is used in dark areas, regardless of the position of the Lens Cover.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Power Adapter/Battery Charger, etc.) and clock battery; and then re-connect it and proceed as usual from the beginning.