EN 15
Date/Time Settings
The date/time is recorded onto the tape at all times, but its display can be turned on or off during playback. ( pg. 38, 49)
POWER Lamp
Power Switch
AY OFF A | M |
PL |
Lock Button
MENU Wheel
1Set the Power Switch to “M” while pressing down the Lock Button located on the switch.
2Open the LCD monitor fully, or pull out the viewfinder fully.
3Press the MENU Wheel in. The Menu Screen appears.
|
|
|
| W IPE / FADER OF F |
|
|
| PROGRAM AE | |
|
|
| EXPOSURE | |
|
|
|
| W. BALANCE |
|
|
|
| CAMERA |
|
|
|
| MANUAL |
|
|
|
| SYSTEM |
|
|
|
| D I SPLAY |
|
|
|
| DSC |
|
|
|
| |
|
|
|
| END |
4Rotate the MENU Wheel to select
“n DISPLAY”, and press it. The DISPLAY Menu appears.
|
| ON SCREEN | – | LCD / TV |
| ||
|
| DATE / T I ME | – | AUTO |
|
| |
|
|
| T I ME CODE | – | OF F |
|
|
|
|
| CLOCK |
| 2 5 . 12 | . 0 | 2 |
|
|
| ADJ . |
| 17 | : 3 0 | |
|
|
|
|
|
|
|
|
RETURN
5Rotate the MENU Wheel to select “CLOCK ADJ.”, and press it. The parameter for “Day” is highlighted.
6Rotate the MENU Wheel to input the day, and press it. Repeat to input the month, year, hour and minute.
CLOCK | 2 5 . 12 | . 02 |
ADJ . | 17 | : 3 0 |
7Rotate the MENU Wheel to select “BRETURN”, and press it twice. The Menu Screen closes.
Built-in Clock’s Rechargeable Lithium Battery
To store the date/time in memory, the clock’s rechargeable lithium battery is integrated in the camcorder. While the camcorder is connected to an AC outlet using the AC Adapter, or while the battery pack attached to the camcorder continues to supply power, the clock’s rechargeable lithium battery is always charged. However, if the camcorder is not used for approx. 3 months, the clock’s lithium battery will become discharged and the date/time stored in memory will be lost. When this occurs, first connect the camcorder to an AC outlet using the AC Adapter for over 24 hours to charge the clock’s rechargeable lithium battery. Then perform the date/ time setting before using the camcorder.
Note that the camcorder can be used without setting the date/time.
NOTE:
Even if you select “CLOCK ADJ.”, if the parameter is not highlighted, the camcorder’s internal clock continues to operate. Once you move the highlight bar to the first date/time parameter (day), the clock stops. When you finish setting the minute and press the MENU Wheel in, the date and time begin operation from the date and time you have just set.