JVC GR-DVX709ED, GR-DVX509ED 86 EN, Angle of the LCD monitor, Camcorder When the LCD monitor’s

86 EN			TROUBLESHOOTING (cont.)
31.	When the image is printed	31.	•This is not a malfunction.	31.	•By recording with “DIS”
	from the printer, a black bar				activated ( pg. 46) this can
	appears at the bottom of the				be avoided.
	screen.
32.	When the camcorder is	32.	•The DV cable was plugged/	32.	•Turn the camcorder’s power
	connected via the DV		unplugged with power		off and on again, then
	connector, the camcorder does		turned on.		operate it.
	not operate.
33.	The rear of the LCD monitor is	33.	•The light used to illuminate	33.	•Close the LCD monitor to
	hot.		the LCD monitor causes it to		turn it off or set the Power
			become hot.		Switch to “OFF”, and let the
					unit cool down.
34.	Images on the LCD monitor	34.	•In places subject to low	34.	•Adjust the brightness and
	appear dark or whitish.		temperature, images become		angle of the LCD monitor.
			dark due to the		( pg. 13)
			characteristics of the LCD
			monitor. When this happens,
			the displayed colours differ
			from those that are actually
			recorded. This is not a defect
			of the camcorder.
			•When the LCD monitor’s
			fluorescent light reaches the
			end of its service life, images
			on the LCD monitor become
			dark. Consult your nearest
			JVC dealer.
35.	Coloured bright spots appear	35.	•The LCD monitor and the	35.
	all over the LCD monitor or the		viewfinder are made with
	viewfinder.		high-precision technology.
			However, black spots or
			bright spots of light (red,
			green or blue) may appear		—
			constantly on the LCD
			monitor or the viewfinder.
			These spots are not recorded
			on the tape. This is not due to
			any defect of the unit.
			(Effective dots: more than
			99.99 %)
36.	The indicators and the image	36.	•This may occur when the	36.
	colour on the LCD monitor are		surface or the edge of the		—
	not clear.		LCD monitor is pressed.
37.	The cassette will not load	37.	•The cassette is in the wrong	37.	•Set it in the right position.
	properly.		position.		( pg. 16)
			•The battery’s charge is low.		•Install a fully charged battery.
					( pg. 10, 11)
38.	The memory card will not load	38.	•The memory card is in the	38.	•Set it in the right position.
	properly.		wrong position.		( pg. 17)
39.	The memory card cannot be	39.	—	39.	•Push in the memory card a
	removed from the camcorder.				few more times. ( pg. 17)