FEATURES FOR RECORDING
Night-Scope
NIGHT Button
VIDEO/MEMORY Switch
Power Switch
AY OFF A | M |
PL |
SNAPSHOT Button
EN 53
Snapshot (For Video Recording)
This feature lets you record still images that look like photographs onto a tape.
1 | Set the VIDEO/MEMORY Switch to “VIDEO”. |
2 | |
Set the Power Switch to “M” while pressing down | |
3 | the Lock Button located on the switch. |
Open the LCD monitor fully, or pull out the | |
4 | viewfinder fully. |
Set “SNAP MODE” to the desired mode. | |
5 | ( pg. 38, 45) |
Press SNAPSHOT. | |
| ● The “O” indication appears and a still |
| image will be recorded for approx. 6 seconds, |
| then the camcorder |
| Standby mode. |
MENU Wheel
Lock Button
● You can perform Snapshot also during |
recording. A still image will be recorded for |
approx. 6 seconds, then the normal recording |
resumes. |
● Regardless of the Power Switch position (“A” |
Makes dark subjects or areas even brighter than they would be under good natural lighting. Although the recorded image is not grainy, it may look as if it is strobing due to the slow shutter speed.
1Set the Power Switch to “M” while pressing down the Lock Button located on the switch.
2Open the LCD monitor fully or pull out the viewfinder fully.
3Press NIGHT so that the
●The shutter speed is automatically adjusted to provide up to 30 times sensitivity.
●“” appears beside “ ” while the shutter speed is being automatically adjusted.
To deactivate Night-Scope…
Press NIGHT again so that the
NOTES:
●During
•Some modes of “Program AE With Special Effects” ( pg. 42).
•“Snapshot Flash
•“GAIN UP” in CAMERA Menu. ( pg. 45)
•“DIS” in MANUAL Menu. ( pg. 46)
●During
or “M”), Snapshot recording takes place using |
the selected Snapshot mode. |
NOTES:
●To remove the shutter sound, refer to “BEEP” on page 48.
●If Snapshot recording is not possible, the “O” indication blinks when SNAPSHOT is pressed.
●If Program AE with special effects ( pg. 42) is engaged, certain modes of Program AE with special effects are disabled during Snapshot recording. In such a case, the icon blinks.
●If SNAPSHOT is pressed when “DIS” is set to “ON” ( pg. 46), the Stabiliser will be disabled.
●During playback as well, all snapshot modes are
available when “ COPY” is set to “OFF” in VIDEO Menu. ( pg. 51) However, the shutter sound is not heard.
●During Snapshot recording, the image displayed in the viewfinder may be partially missing. However, there is no effect in the recorded image.
●When a cable is connected to the AV connector, the shutter sound is not heard from the speaker, however it is recorded onto the tape.
Motor Drive Mode
Keeping SNAPSHOT pressed in step 5 provides an effect similar to serial photography. (Interval between still images: approx. 1 second)
●The Motor Drive mode is disabled when “REC
SELECT” is set to “/”. ( pg. 38, 50)