JVC GR-PD1, LYT1193-001A manual 64 EN, For More Accurate Editing, Diagnosing VCR/Camcorder Timing

64 EN USING THE REMOTE CONTROL UNIT (cont.)

For More Accurate Editing

R.A.EDIT

ON/OFF

Some VCRs make the transition from Record-Pause to Record mode faster than others. Even if you begin editing for the camcorder and the VCR at exactly the same time, you may lose scenes you wanted, or find that you have recorded scenes you did not want. For a cleanly edited tape, confirm and adjust the timing of the camcorder against your VCR.

Diagnosing VCR/Camcorder Timing

1Play back the tape in the camcorder, then point the remote control at the camcorder’s remote sensor and press R.A.EDIT ON/OFF.

Random Assemble Editing Menu appears.

Program 1

	I N	OUT MODE	Random Assemble
1 – –	– – : – – ~		Editing Menu
2	~

3~

4~

5~

6~

7~

8~

T I ME CODE	– – : – –
TOTAL	0 0 : 00

2Perform Random Assemble Editing on Program 1 only. In order to check VCR and camcorder timing, select the beginning of a scene transition as your Edit-In point.

3Play back the dubbed scene.

●If any images from the scene prior to the transition you chose for your Edit-In point were recorded, that means your VCR moves too quickly from Record-Pause to Record mode.

●If the scene you tried to dub starts in progress, the VCR is slow to start recording.

Adjustment Of VCR/Camcorder Timing

4Press R.A.EDIT ON/OFF to make the Random Assemble Editing menu disappear, then press the MENU Wheel in. The Menu Screen appears.

5Rotate the MENU Wheel to select “t VIDEO”, and press it. The VIDEO Menu appears.

6Rotate the MENU Wheel to select “SYNCHRO”, and press it. The value for “SYNCHRO” is highlighted.

7Based on the diagnostics performed, you can now advance the VCR’s record timing by rotating the MENU Wheel towards R. You can also delay the VCR’s record timing by rotating the MENU Wheel towards T.

The adjustment range is from –1.3 to +1.3 seconds, in 0.1-second increments.

Press the MENU Wheel in to finish the setting.

8Rotate the MENU Wheel to select “BRETURN”, and press it twice.

Now perform Random Assemble Editing beginning with step 6 on page 62.

NOTES:

●Before performing actual Random Assemble Editing, do a few Random Assemble Editing trial runs to check whether the value you have input is appropriate or not, and make adjustments accordingly.

●Depending on the recorder, there may be situations where the timing difference cannot be fully corrected.