JVC LYT1193-001A Set this camcorder’s Power Switch to P, Formats, set i.LINK OUT to AUTO. In this

EN 53

●Depending on the tape source input, images may appear with horizontal jitter on the camcorder’s LCD monitor and viewfinder during dubbing. This does not affect the actual recording.

Dubbing To Or From A Video Unit Equipped With An i.LINK Connector (Digital Dubbing)

Using an i.LINK cable (optional), it is possible to dub recorded scenes in DV format from the camcorder onto another video unit equipped with i.LINK connector. Since a digital signal is sent, there is little if any image or sound deterioration.

Scenes recorded in PS50 or HI-RES mode can be dubbed only to another same model of this unit.

i.LINK Output Select	Connector Cover*
Switch
	To i.LINK IN/OUT
	i.LINK cable
	(optional)
To i.LINK IN/OUT

Video unit equipped with

i.LINK connector

* When connecting the cable, open the cover.

NOTES:

●It is recommended to use the AC Power Adapter/ Charger as the power supply instead of the battery pack. ( pg. 11)

●When using an i.LINK cable, be sure to use the optional JVC VC-VDV204U i.LINK cable.

●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

To use this camcorder as a player

1	Make sure all units are turned off.
2	Connect this camcorder to a video unit equipped
	with an i.LINK input connector using an i.LINK
3	cable as shown in the illustration.
	Set this camcorder’s Playback Mode Switch to
4	“VIDEO”.
	Set this camcorder’s Power Switch to “P”
	while pressing down the Lock Button located on
	the switch.
5 Set “i.LINK OUT” to “SW”. ( pg. 33, 37)
	● If, in future, the connected video unit
	automatically detects the DV and MPEG2	FEATURES
	formats, set “i.LINK OUT” to “AUTO”. In this
6	case, proceed to step 7.
	Set the i.LINK Output Select Switch on this
	camcorder to “DV” to output scenes recorded in
	DV mode, or “MPEG2” to output scenes	ADVANCED
7	recorded in HI-RES or PS50 mode.
	Turn on the video unit’s power.
8	Insert the source cassette in this camcorder.
9	Insert the recording cassette in the video unit.

10 Press 4·9 on this camcorder to start playback of the source cassette.

11 At the point you want to start dubbing, engage the video unit’s Record mode.

12 To pause dubbing, engage the video unit’s Record-Pause mode and press 4·9 on this camcorder.

13 Repeat steps 10 – 12 for additional editing. Stop the video unit and camcorder.

NOTES:

●If a blank portion or disturbed image is played back on the player during dubbing, unusual images may be dubbed or the dubbing may stop.

●If a scene which has been paused during recording is dubbed to other devices, playback may stop at the point.

●If “Wipe Or Fader Effects” ( pg. 48), “Special Effects” ( pg. 49), “Playback Zoom (DV only)” ( pg. 57) or “TIME CODE” ( pg. 37) is set, only the original playback image is output from the i.LINK IN/OUT connector.

CONTINUED ON NEXT PAGE