JVC LYT1193-001A, GR-PD1 manual Special Effects, To deactivate the selected effect

					EN 49
TWILIGHT: Makes evening scenes look more			Special Effects
natural. White Balance ( pg. 46) is automatically
set to “ ”, but can be changed to your desired
	Using the following 4 Effect Modes allows you to
setting. When Twilight is chosen, the camcorder
automatically adjusts the focus from approx. 10 m	provide special effects for your shooting.
to infinity. From less than 10 m, adjust the focus					CLASSIC FILM: Gives recorded scenes a
manually.
	strobe effect.
1 Set the Recording Mode Switch to “HI-RES”,					MONOTONE: Like classic black and white
“PS50” or “DV”.	films, your footage is shot in B/W. Using this effect
	with “DV WIDE” set to ”SQUEEZE” ( pg. 36)
● Some modes of Program AE cannot be used
	provides “classic film” effect.
with the Recording Mode Switch set to
“MEMORY”.					SEPIA: Recorded scenes have a brownish tint
2 Set the Power Switch to “M” while pressing down	like old photos. Using this effect with “DV WIDE”
the Lock Button located on the switch.	set to ”SQUEEZE” ( pg. 36) provides “classic film”
	effect.
3 Open the LCD monitor fully, or pull out the
					STROBE: Your recording looks like a series of
viewfinder fully.
	consecutive snapshots.
4 Press P.AE. The PROGRAM AE screen appears.
	NOTES:
5 Rotate the MENU Wheel to select the desired
mode, and press it.	● When the Recording Mode Switch is set to “HI-
		RES” or “MEMORY”, “MONOTONE” is only
6 Press the MENU Wheel in to activate the selected
		available.
effect.	● “SEPIA”, “CLASSIC FILM” and ”STROBE” are not
● The selected effect indicator appears.		activated when the recording mode is set to “HI-
To deactivate the selected effect…		RES”.
Select “OFF” in step 5. Or, set the Power Switch to	1 Set the Recording Mode Switch to “PS50” or
“A”.
				“DV”.
NOTE:
				● Some modes of Special Effects cannot be used
Program AE can be changed during recording or					in “HI-RES” or “MEMORY” mode.
during Record-Standby.	2 Set the Power Switch to “M” while pressing down
IMPORTANT:				the Lock Button located on the Switch.
Some modes of Program AE cannot be used with	3 Open the LCD monitor fully, or pull out the
certain Wipe/Fader effects. If an unusable mode is				viewfinder fully.
selected, the indicator of Wipe/Fader effects blinks	4 Press EFFECT. The EFFECT screen appears.
or goes out.	5 Rotate the MENU Wheel to select the desired
				mode, and press it.
	6 Press the MENU Wheel in to activate the selected
				effect.
				● The selected effect indicator appears.
	To deactivate the selected effect...
	Select “OFF” in step 5. Or, set the Power Switch to
	“A”.
	IMPORTANT:
	Some modes of Special Effects cannot be used with
	certain Wipe/Fader effects. If an unusable mode is
	selected, the indicator of Wipe/Fader effects blinks.

ADVANCED FEATURES