JVC GR-SXM86ED OUT 9 the scene you want to edit and press Pause, Editing cable and the A/V cable

					EN	43
Original tape (camcorder)				AUTOMATIC EDITING TO VCR
	1	3	2
				Rewind the tape in the camcorder to the beginning of
	IN	OUT IN OUT	IN OUT 9 the scene you want to edit and press PAUSE (6).

10 Point the remote control towards the VCR’s infrared sensor and press VCR REC STBY (q6), or manually engage the VCR’s Record-Pause mode.

Edited tape (VCR)

STOP (5) Button

REW (2) Button

PAUSE (6) Button

Power Switch

Recording Start/Stop Button

11 Press the Recording Start/Stop Button on the camcorder to begin Automatic Editing, and the previously selected scenes are copied to the VCR in the specified order.

While editing, the R.A. Edit counter of the scene which is being copied is shown with a blinking highlight.

•Pressing START/STOP on the remote control does not start editing.

12 When all selected scenes have been copied, the camcorder and VCR enter the Still or Pause mode. Press STOP (5) on both units. To make the R.A. Edit counter display disappear, press R.A.EDIT ON/OFF. •When finished editing, be sure to disconnect the

editing cable and the A/V cable.

NOTES:

●If you performed step 1 on page 41 (“MAKE CONNECTIONS”), keep the remote control pointed at the VCR during editing.

●The on-screen display only appears while the camcorder searches for each scene.

●There may be noise at in- or out-points on the edited tape with certain VCRs.

Remote Sensor

PAUSE

VCR REC STBY

R.A.EDIT

ON/OFF