Camco P.0 Series, P.9 Series, P.5 Series, P Series manual Options, E.U.I.2 Extended User Interface

5 OPTIONS

P.21

5.1 E.U.I.2 (Extended User Interface)

CAUTION! Always switch off and unplug the TECTON from mains, before making alterations to the E.U.I. card.

The E.U.I. card contains the Rear XLR Panel as standard. Other input cards are available (See 5.1.1 What Are The Possibilities Using The E.U.I.2?).

To remove the E.U.I.2 unscrew the two Phillips head screws at the left and right end of the XLR-Panel and carefully slide out the E.U.I.2.

To refit the E.U.I.2, carefully insert it. Pay attention that the cable is not clamped.

ATTENTION! Don’t forget to tighten the screws!

USER MANUAL

TECTON POWER AMP SERIES

5.1.1 What Are The Possibilities Using The E.U.I.2?

The E.U.I.2 is a very powerful interface, which allows access to most of the system parameters, such as volume, input signal, mute, output current, clip signal, temperature and more. You can use the E.U.I.2 as a filter, remote control, signal processing device and more… Please contact your dealer/distributor or CAMCO to customise the E.U.I.2 according to your wishes.