Camco P.4 Series Frequency Response, Input Impedance, Voltage Gain, Protection Circuits, Limiter

7 SPECIFICATION

P.25

Frequency Response	20 Hz - 20 kHz ± 0,15 dB
	8 Ω load, 10 dB below rated power
Input Impedance	14 kΩ balanced
Voltage Gain	selectable: 26 dB, 32 dB, or 1,4 V input sensitivity
Protection Circuits	inrush-current limitation, temperature monitoring of transformer and heat-sinks,
	output DC protection, power transistor SOA protection, output over current protection,
	mains fuses protection
Limiter	switchable clip limiter
Fan	temperature dependent speed-controlled axial fan
Ground Lift	input ground lift switch on back panel
Indicators	LEDs for Mode, Signal, Clip, Output Current and faults for example like DC
Input Connectors	3-pin XLR, male and female per channel, pin 2 = inphase (hot)
Output Connectors	one 4-pole SPEAKON connector for each output channel (bi-amping possible)
Modes of Operation	Stereo, Mono-Bridge and Parallel-Mono
Options	Extended User Interface / E.U.I. 2 – modules for any kind of EQ
THD+N (typical)	< 0,01 %
20 Hz - 10 kHz, 8 Ω load,
0 dB below rated power
SMPTE (typical)	< 0,01 %
8 Ω load,
0 dB below rated power
Damping Factor	> 400
8 Ω load, 1 kHz and below
Dimensions (WxHxD)	483 x 88,9 x 330,7 mm (19”, 2U)
Net Weight	9,4 kg
Shipping Dimensions (WxHxD)	540 x 135 x 540 mm (0,04 m3)
Shipping Weight	11 kg
	Subject to technical alterations without prior notice

USER MANUAL

TECTON POWER AMP SERIES