Camco P.3 Series, P.9 Series, P.5 Series manual Mode Selector, Wiring 1 E.U.I. and XLR Connection

Page 16

3 INSTALLATION

3.7 Mode Selector

The switch on the rear panel changes the operating mode. Switch the power switch to the Off position to make changes on the Mode Selector. When the amplifier is switched on again, the selected mode will operate.

3.8 Wiring

3.8.1 E.U.I. and XLR Connection

XLR: Pin 1 = Ground (or lifted via 15 Ω resistor) (See 3.5 Ground Lift) Pin 2 = Hot (inphase)

Pin 3 = Cold (out of phase)

Always use symmetrical (balanced) shielded cable to connect the amplifier.

 

Input

 

Input

LINK B

LINK A

Channel B

Channel A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

1

2

1

1

2

1

2

 

3

 

3

 

3

 

3

P.14

USER MANUAL

TECTON POWER AMP SERIES

To Channel B

To

Channel A

Input

Ground

Lift

Input Ground Lift in position: grounded

Image 16 Camco P.3 Series, P.9 Series, P.5 Series, P Series, P.0 Series, P.2 Series Mode Selector, Wiring 1 E.U.I. and XLR Connection
Contents Page Page Information for USE for Important Safety Instructions Important Safety InstructionsExplanation of Symbols / Safety Safety EC Declaration of Conformity Manufacturers NameManufacturers Address Declares that the product with the model nameContents Welcome to Camco WelcomeUnpacking Tecton is a Class-H power amplifier with a power output AmplifierFacilities Tecton The Front Tecton The RearFactory Settings Front panelInstallation Mains SupplyOn/Off Switch MountingCooling Mode IndicatorsGround Lift Mode Selector Wiring 1 E.U.I. and XLR ConnectionMono-Bridge Operation One-channel mono bridged operation Stereo Operation, 2 Channel OperationParallel-Mono Operation Operation Speakon ConnectionControls Volume Control Limiter SwitchGain Selector Gain and Input SensitivityIndicators Output Current LEDs Signal LEDs multifunctionalPower Amp Protection Systems 4.3.1 Clip Limiter Clip LEDsSOA Protection DC ProtectionMains Protections Inrush Current Limitation Mains Over Voltage DetectionMains Failure Detection Fuse ProtectionOptions What Are The Possibilities Using The E.U.I.2?E.U.I.2 Extended User Interface Troubleshooting Specification Output PowerSignal to Noise-Ratio Power Consumption @ 2301400 W @ 2 Ω 1100 W @ 2 Ω 670 W @ 2 Ω Indicators Input ConnectorsOutput Connectors Dimensions WxHxDMeasurements Measurements of a typical performanceMeasurements of a typical performance of Tecton Ch1, Ch2 Measurements of a typical performance of Tecton Tecton 24.4 Measurements of a typical performance Tecton 14.2 Measurements of a typical performance Warranty Information Expired Warranty Nature Of ProblemOwner’s Information Shipping AddressDECOMISSIONINGINFORMATION/12 Maintenance InformationDecomissioning Company Information Mailing AddressTelephone Facsimile