Camco P.7 Series, P Series DECOMISSIONINGINFORMATION/12, Maintenance Information, Decomissioning

Page 35

DECOMISSIONINGINFORMATION/12

MAINTENANCE11

P.33

11 Maintenance Information

Cleaning and servicing the inside of the amplifier must never carry out by un- qualified personnel.The amplifier must never be opened by unqualified person- nel.

Cleaning and servicing work on the inside of the amplifier must only be carried out by qualified personnel.

Qualified personnel is defined as a person who has gained specialised relevant knowledge of electronic engineering through education, training and experi- ence and who has sufficient knowledge of all relevant governmental work safety regulations to be in a position to judge the safe functioning of power amplifiers based on technical rules according to IEC 60065.

(IEC 60065 (DIN EN 60065) “Safety Requirements for Audio, Video or simlar Electronic Appliances”)

In order to guarantee the safe functioning of the amplifier, it has to be checked at least once, depending on its application and usage, by a properly qualified person.

Advice on how to carry out these checks can be found in DIN VDE 0702-1“Safety Checks for Electronic Appliances”.

An amplifier that is considered to be unsafe must be labelled accordingly and stored in a safe place to prevent this amplifier being used mistakenly.

USER MANUAL

TECTON POWER AMP SERIES

12 Decomissioning

During the decomissioning process of the amplifier, all legally prescribed rules and procedures must be adhered to.

Image 35

Contents Page Page Information for USE for Important Safety Instructions Important Safety InstructionsExplanation of Symbols / Safety Safety Declares that the product with the model name EC Declaration of ConformityManufacturers Name Manufacturers AddressContents Unpacking WelcomeWelcome to Camco Amplifier Tecton is a Class-H power amplifier with a power outputTecton The Front Tecton The Rear FacilitiesFront panel Factory SettingsMains Supply InstallationMounting On/Off SwitchGround Lift Mode IndicatorsCooling Wiring 1 E.U.I. and XLR Connection Mode SelectorParallel-Mono Operation Stereo Operation, 2 Channel OperationMono-Bridge Operation One-channel mono bridged operation Speakon Connection OperationGain and Input Sensitivity Controls Volume ControlLimiter Switch Gain SelectorSignal LEDs multifunctional Indicators Output Current LEDsDC Protection Power Amp Protection Systems 4.3.1 Clip LimiterClip LEDs SOA ProtectionFuse Protection Mains Protections Inrush Current LimitationMains Over Voltage Detection Mains Failure DetectionE.U.I.2 Extended User Interface What Are The Possibilities Using The E.U.I.2?Options Troubleshooting Power Consumption @ 230 SpecificationOutput Power Signal to Noise-Ratio1400 W @ 2 Ω 1100 W @ 2 Ω 670 W @ 2 Ω Dimensions WxHxD IndicatorsInput Connectors Output ConnectorsMeasurements of a typical performance MeasurementsMeasurements of a typical performance of Tecton Ch1, Ch2 Measurements of a typical performance of Tecton Tecton 24.4 Measurements of a typical performance Tecton 14.2 Measurements of a typical performance Warranty Information Shipping Address Expired WarrantyNature Of Problem Owner’s InformationDecomissioning Maintenance InformationDECOMISSIONINGINFORMATION/12 Facsimile Company InformationMailing Address Telephone