Panasonic WV-BP554 manual Installation of Auto Iris Lens Connector

Page 12

Installation of Auto Iris Lens Connector

Install the lens connector (YFE4191J100) when using a video drive ALC lens.

The installation should be made by qualified ser- vice personnel or system installers.

(1)Cut the iris control cable at the edge of the lens connector to remove the existing lens connector and then remove the outer cable cover as shown in the diagram below.

The pin assignment of the lens connector is as fol- lows:

Pin 1: Power source; +9V DC, 50mA Max.

Pin 2: Not used

Pin 3: Video signal; 1.3 V[p-p]/40 kΩ

Pin 4: Shield, ground

Rib

Pin 3

Pin 1

Pin 4

Pin 2

(2)After connection, assemble the lens connector as follows.

Connector

CoverAutomatic

Iris Lens

Heat

Shrinkable

Tubes

Iris Control

Cable

Connector

Note: When the iris control cable is too thick to lock the connector cover with the connector base, cut off the rib on the connector.

(Select VIDEO for LENS DRIVE of the CAM SET UP menu.)

-10-

Image 12

Contents WV-BP550/WV-BP554 Symbol, within an equilateral triangle, is Contents Features PrefacePrecautions Clean the CCD faceplate with careDo not attempt to disassemble the camera Handle the camera with careMajor Operating Controls and Their Functions WV-BP554Auto Iris Lens Connector Flange-back Adjusting RingGen-lock Termination Switch Hi-Z, G/L 75Ω Power indicatorVideo Output Connector Video OUT Power Cord SocketAlarm Output Terminal Alarm OUT/GND AC/DC Compatible Input Terminal DC 12V IN/AC 24VDC Power Supply ConnectionsWV-BP550 120V AC 60Hz WV-BP554 12V DC/24V ACAC Power Supply Recommended wire gauge sizes for 24V AC lineRG-6U Installation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Installation of Camera Mounting from the bottomMounting from the top SET UP Camera Setup MenuMotion Detector Setup Operation All Reset OperationOpening the Setup Menu Editing the CAM SET UP MenuImportant Notice Editing the Special menu Setting Procedures Camera Identification Camera ID SettingTo edit the Camera ID To enter a blank space in the Camera IDLight Control Setting ALC/ELC To return to the CAM SET UP menuTo erase all characters in the editing area To determine the display position of the Camera IDALC Mode with SUPER-D on Super Dynamic Function SUPER-DALC Mode with SUPER-D OFF and ELC Mode Shutter Speed Setting Shutter Gain Control Setting AGC ON/OFF Electronic Sensitivity Enhancement Sens UPSynchronization Setting Sync Important NoticesVS Gen-lock Mode Extvs EntLine-lock Sync Mode LL Motion Detector Setting Motion DET Lens Drive Signal Selection Lens DriveAperture Gain Setting AP Gain Pedestal Level Setting PedestalSpecial Menu Special Camera Picture Upside Down PositioningPrevention of Blooming and Smear Specifications Standard Accessories Optional AccessoriesVideo Imaging Systems Company Regional Offices