Panasonic WV-BP554 manual Special Menu Special, Camera Picture Upside Down Positioning

9. Special Menu (SPECIAL)

This menu lets you adjust and set up the video signal of the camera to meet your requirements.

Move the cursor to END on the bottom line of the CAM

SET UP menu and press or simultaneously for 2 seconds or longer. The SPECIAL menu appears on the monitor as shown below.

	** CAM SET UP **				** SPECIAL **
CAMERA ID			OFF	↵	UP SIDE DOWN	OFF
ALC/ELC			ALC	↵
SHUTTER			---		AP GAIN	....I....
AGC			ON		PEDESTAL	.I
SENS		UP	OFF			-	+
SYNC			INT
MOTION DET			OFF	↵	CAMERA RESET	PUSH SW
LENS		DRIVE	DC
		SET UP ENABLE			RET END
	END

9-1. Camera Picture Upside Down Positioning

(UP SIDE DOWN)

1.Move the cursor to the UP SIDE DOWN parameter.

2.Select ON when you want to turn the picture

upside down.

9-2. Aperture Gain Setting (AP GAIN)

1.Move the cursor to the AP GAIN parameter.

2.While observing the vector scope or video monitor, move the “I” cursor to adjust the aperture gain level.

9-3. Pedestal Level Setting (PEDESTAL)

1.Move the cursor to the PEDESTAL parameter.

2.While observing the wave form monitor/oscillo- scope or video monitor, move the “I” cursor to adjust the pedestal level (black level).

To reset to the factory settings

1.Move the cursor to the CAMERA RESET parame- ter. The words PUSH SW start blinking.

2.While holding down and , press for 2 seconds or longer. The camera is reset to the fac- tory settings.

To close the SPECIAL menu and return to the CAM SET UP menu

Move the cursor to RET and press .

To close the SPECIAL menu and return to the camera picture

Move the cursor to END and press .

-30-