Panasonic WV-BP554 manual Setting Procedures, Camera Identification Camera ID Setting

Page 21

SETTING PROCEDURES

1.Camera Identification (CAMERA ID) Setting

You can use the camera identification (CAMERA ID) to assign a name to the camera. The camera ID consists of up to 16 alphanumeric characters. You can select whether to have the camera ID displayed on the moni- tor screen or not.

** CAM SET UP **

CAMERA ID

OFF

ALC/ELC

ALC

SHUTTER

---

 

AGC

 

ON

 

SENS

UP

OFF

 

SYNC

 

INT

 

MOTION DET

OFF

LENS

DRIVE

DC

 

END

SET UP ENABLE

To edit the CAMERA ID

1. Move the cursor to the CAMERA ID parameter.

2. Press . The CAMERA ID menu appears. The cursor on the letter “0” starts blinking.

 

 

Character Cursor

 

 

 

123456789

 

0

 

 

 

ABCDEFGHIJKLM

Character

 

NOPQRSTUVWXYZ

().,'":;&#!?=

Area

+-*/%$

 

SPACE

Command

POSI RET END RESET

 

Pointer

Editing

Area

CAMERA ID menu

3.Move the cursor to the character you want to change by pressing / / / .

4.After selecting the character, press . The selected character appears in the editing area. (The pointer in the editing area moves to the right automatically at this moment.)

5.Repeat the steps above until all characters are edited.

To enter a blank space in the CAMERA ID

Move the cursor to SPACE and press .

To edit a specific character in the CAMERA ID

1.Move the cursor to the editing area by pressing

.

-19-

Image 21
Contents WV-BP550/WV-BP554 Symbol, within an equilateral triangle, is Contents Preface FeaturesClean the CCD faceplate with care PrecautionsDo not attempt to disassemble the camera Handle the camera with careWV-BP554 Major Operating Controls and Their FunctionsFlange-back Adjusting Ring Auto Iris Lens ConnectorGen-lock Termination Switch Hi-Z, G/L 75Ω Power indicatorPower Cord Socket Video Output Connector Video OUTAlarm Output Terminal Alarm OUT/GND AC/DC Compatible Input Terminal DC 12V IN/AC 24VConnections DC Power SupplyWV-BP550 120V AC 60Hz WV-BP554 12V DC/24V ACRecommended wire gauge sizes for 24V AC line AC Power SupplyRG-6U Installation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Installation of Camera Mounting from the bottomMounting from the top Camera Setup Menu SET UPMotion Detector All Reset Operation Setup OperationOpening the Setup Menu Editing the CAM SET UP MenuImportant Notice Editing the Special menu Camera Identification Camera ID Setting Setting ProceduresTo edit the Camera ID To enter a blank space in the Camera IDTo return to the CAM SET UP menu Light Control Setting ALC/ELCTo erase all characters in the editing area To determine the display position of the Camera IDSuper Dynamic Function SUPER-D ALC Mode with SUPER-D onALC Mode with SUPER-D OFF and ELC Mode Shutter Speed Setting Shutter Electronic Sensitivity Enhancement Sens UP Gain Control Setting AGC ON/OFFImportant Notices Synchronization Setting SyncEnt VS Gen-lock Mode ExtvsLine-lock Sync Mode LL Motion Detector Setting Motion DET Drive Lens Drive Signal Selection LensPedestal Level Setting Pedestal Aperture Gain Setting AP GainSpecial Menu Special Camera Picture Upside Down PositioningPrevention of Blooming and Smear Specifications Optional Accessories Standard AccessoriesRegional Offices Video Imaging Systems Company