Panasonic WV-BP554 manual Opening the Setup Menu, Editing the CAM SET UP Menu, Important Notice

Page 19

• Opening the Setup Menu

Press and hold down for a second or longer.

** CAM SET UP **

Blinking

CAMERA ID

OFF

 

ALC/ELC

ALC

 

SHUTTER

---

 

 

AGC

 

ON

 

 

SENS

UP

OFF

 

 

SYNC

 

INT

 

 

MOTION DET

OFF

 

LENS

DRIVE

DC

 

 

END

SET UP DISABLE

 

** CAM SET UP **

CAMERA ID

OFF

ALC/ELC

ALC

SHUTTER

---

 

AGC

ON

 

SENS UP

OFF

 

SYNC

INT

 

MOTION DET

OFF

LENS DRIVE

DC

 

END SET UP DISABLE

The CAM SET UP menu appears on the monitor as shown above.

Check the current settings on the menu.

Refer to the sections below for a detailed description of menu items. If you decide not to make any changes after checking the current settings, move the cursor to

END at the start of the bottom line, and press to close the CAM SET UP menu and return to normal camera picture mode.

Note: If no button is pressed for 6 minutes while the CAM SET UP menu or any other setting menu is displayed, displaying the menu is automatically canceled and the mode returns to the normal cam- era picture.

• Editing the CAM SET UP Menu

Important Notice:

When the words SET UP DISABLE appear on the bottom line of the CAM SET UP menu, you cannot change the currently active settings. This is to pre- vent accidental changing of the settings.

To edit the CAM SET UP menu (change settings), use

and or and to move the cursor to SET UP DISABLE in the bottom line.

Press . SET UP DISABLE changes to SET UP ENABLE. Move the cursor to END, then to the item(s) you want to change.

-17-

Image 19
Contents WV-BP550/WV-BP554 Symbol, within an equilateral triangle, is Contents Preface FeaturesHandle the camera with care PrecautionsClean the CCD faceplate with care Do not attempt to disassemble the cameraWV-BP554 Major Operating Controls and Their FunctionsPower indicator Auto Iris Lens ConnectorFlange-back Adjusting Ring Gen-lock Termination Switch Hi-Z, G/L 75ΩAC/DC Compatible Input Terminal DC 12V IN/AC 24V Video Output Connector Video OUTPower Cord Socket Alarm Output Terminal Alarm OUT/GNDWV-BP554 12V DC/24V AC DC Power SupplyConnections WV-BP550 120V AC 60HzRecommended wire gauge sizes for 24V AC line AC Power SupplyRG-6U Installation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Mounting from the bottom Installation of CameraMounting from the top Camera Setup Menu SET UPMotion Detector All Reset Operation Setup OperationEditing the CAM SET UP Menu Opening the Setup MenuImportant Notice Editing the Special menu To enter a blank space in the Camera ID Setting ProceduresCamera Identification Camera ID Setting To edit the Camera IDTo determine the display position of the Camera ID Light Control Setting ALC/ELCTo return to the CAM SET UP menu To erase all characters in the editing areaSuper Dynamic Function SUPER-D ALC Mode with SUPER-D onALC Mode with SUPER-D OFF and ELC Mode Shutter Speed Setting Shutter Electronic Sensitivity Enhancement Sens UP Gain Control Setting AGC ON/OFFImportant Notices Synchronization Setting SyncEnt VS Gen-lock Mode ExtvsLine-lock Sync Mode LL Motion Detector Setting Motion DET Drive Lens Drive Signal Selection LensCamera Picture Upside Down Positioning Aperture Gain Setting AP GainPedestal Level Setting Pedestal Special Menu SpecialPrevention of Blooming and Smear Specifications Optional Accessories Standard AccessoriesRegional Offices Video Imaging Systems Company